296 prompts matching "Rod at an angle to both card planes and rotates it into a position parallel to t"
Teach me: The full section and when it is used
You are my personal SS3 Technical Drawing tutor. Teach me the full section and when it is
Let me explain: Removed and revolved sections
I have just studied removed and revolved sections in my SS3 Technical Drawing class. Let m
Teach me: Constructing an isometric scale
You are my personal SS3 Technical Drawing tutor. Teach me constructing an isometric scale,
Let me explain: Drawing an isometric circle by the four-centre method
I have just studied drawing an isometric circle by the four-centre method in my SS3 Technical Drawing class. Let me explain it back to you in my own words, then tell me plainly what I got wrong or left out. Ask me one follow-up question afterwards to test whether I really understood it.
launch and paste in:
Teach me: Cavalier and cabinet oblique
You are my personal SS3 Technical Drawing tutor. Teach me cavalier and cabinet oblique, us
Let me explain: Oblique circles and curves
I have just studied oblique circles and curves in my SS3 Technical Drawing class. Let me e
Practice set: Freehand perspective sketching of an interior
Act as my SS3 Technical Drawing tutor. Give me five practice questions on freehand perspec
Quiz: The position of the plan and end views
Act as my SS3 Technical Drawing tutor and quiz me on the position of the plan and end view
Teach me: Why a line appears shorter than its true length
You are my personal SS3 Technical Drawing tutor. Teach me why a line appears shorter than
Quiz: Finding true length by rotation
Act as my SS3 Technical Drawing tutor and quiz me on finding true length by rotation. Ask
Quiz: The frustum of a cone and of a pyramid
Act as my SS3 Technical Drawing tutor and quiz me on the frustum of a cone and of a pyrami
Practice set: Developing a transition piece
Act as my SS3 Technical Drawing tutor. Give me five practice questions on developing a tra
Practice set: Locating the centre of gravity of a given lamina
Act as my SS3 Technical Drawing tutor. Give me five practice questions on locating the cen
Spot my mistake: Dividing a line into equal parts by measuring with a rule instead of by construction
Act as my SS3 Technical Drawing tutor. Write a short answer on dividing a line into equal
Spot my mistake: Doubling every side of a figure in order to double its area
Act as my SS3 Technical Drawing tutor. Write a short answer on doubling every side of a fi
Spot my mistake: Dimensioning every part fully on an assembly drawing
Act as my SS3 Technical Drawing tutor. Write a short answer on dimensioning every part ful
Spot my mistake: Sketching a tool in orthographic views where a pictorial view is asked for
Act as my SS3 Technical Drawing tutor. Write a short answer on sketching a tool in orthogr
Spot my mistake: Assuming a try square and a bevel do the same job
Act as my SS3 Technical Drawing tutor. Write a short answer on assuming a try square and a
Spot my mistake: Assuming a raft foundation is chosen where the ground is strongest
Act as my SS3 Technical Drawing tutor. Write a short answer on assuming a raft foundation
Spot my mistake: Assuming a flat roof is laid truly level
Act as my SS3 Technical Drawing tutor. Write a short answer on assuming a flat roof is lai