260 prompts matching "Success: division into seven parts accurate to within 0.5 mm across the whole li"
Quiz: Representing brick, block and concrete in section
Act as my SS3 Technical Drawing tutor and quiz me on representing brick, block and concret
Let me explain: Representing timber, insulation and hardcore
I have just studied representing timber, insulation and hardcore in my SS3 Technical Drawi
Spot my mistake: A section hatched with the wrong material convention
Act as my SS3 Technical Drawing tutor. Write a short answer on a section hatched with the
Quiz: Fillet and butt weld symbols
Act as my SS3 Technical Drawing tutor and quiz me on fillet and butt weld symbols. Ask fiv
Let me explain: Reading weld size and length from a symbol
I have just studied reading weld size and length from a symbol in my SS3 Technical Drawing
Practice set: Annotating a joint with the correct weld symbol
Act as my SS3 Technical Drawing tutor. Give me five practice questions on annotating a joi
Quiz: Upper and lower limits of size
Act as my SS3 Technical Drawing tutor and quiz me on upper and lower limits of size. Ask f
Let me explain: Clearance, interference and transition fits
I have just studied clearance, interference and transition fits in my SS3 Technical Drawin
Practice set: Computing limits from a stated fit
Act as my SS3 Technical Drawing tutor. Give me five practice questions on computing limits
Quiz: Metric, square and acme thread forms
Act as my SS3 Technical Drawing tutor and quiz me on metric, square and acme thread forms.
Let me explain: Bolts, studs and set screws
I have just studied bolts, studs and set screws in my SS3 Technical Drawing class. Let me
Practice set: Drawing a bolted joint
Act as my SS3 Technical Drawing tutor. Give me five practice questions on drawing a bolted
Quiz: Lock nuts and castle nuts
Act as my SS3 Technical Drawing tutor and quiz me on lock nuts and castle nuts. Ask five q
Let me explain: Spring washers and tab washers
I have just studied spring washers and tab washers in my SS3 Technical Drawing class. Let
Practice set: Drawing a locked nut assembly
Act as my SS3 Technical Drawing tutor. Give me five practice questions on drawing a locked
Practice set: Drawing a half section of a given component
Act as my SS3 Technical Drawing tutor. Give me five practice questions on drawing a half s
Quiz: The broken-out section
Act as my SS3 Technical Drawing tutor and quiz me on the broken-out section. Ask five ques
Let me explain: Removed and revolved sections
I have just studied removed and revolved sections in my SS3 Technical Drawing class. Let m
Quiz: Isometric drawing against true isometric projection
Act as my SS3 Technical Drawing tutor and quiz me on isometric drawing against true isomet
Let me explain: Drawing an isometric circle by the four-centre method
I have just studied drawing an isometric circle by the four-centre method in my SS3 Technical Drawing class. Let me explain it back to you in my own words, then tell me plainly what I got wrong or left out. Ask me one follow-up question afterwards to test whether I really understood it.
launch and paste in: