232 prompts matching "Success: both folded models close with a gap of less than 2 mm"
Spot my mistake: Dimensioning every part fully on an assembly drawing
Act as my SS3 Technical Drawing tutor. Write a short answer on dimensioning every part ful
Spot my mistake: Sketching a tool in orthographic views where a pictorial view is asked for
Act as my SS3 Technical Drawing tutor. Write a short answer on sketching a tool in orthogr
Spot my mistake: Assuming a try square and a bevel do the same job
Act as my SS3 Technical Drawing tutor. Write a short answer on assuming a try square and a
Spot my mistake: Assuming a raft foundation is chosen where the ground is strongest
Act as my SS3 Technical Drawing tutor. Write a short answer on assuming a raft foundation
Spot my mistake: Treating a casement window and a sash window as the same type
Act as my SS3 Technical Drawing tutor. Write a short answer on treating a casement window
Spot my mistake: Assuming every wall in a building carries load
Act as my SS3 Technical Drawing tutor. Write a short answer on assuming every wall in a bu
Spot my mistake: Reading a weld symbol below the reference line as though it sat above it
Act as my SS3 Technical Drawing tutor. Write a short answer on reading a weld symbol below
Spot my mistake: Assuming a transition fit always leaves clearance
Act as my SS3 Technical Drawing tutor. Write a short answer on assuming a transition fit a
Spot my mistake: Assuming a plain washer locks a nut against loosening
Act as my SS3 Technical Drawing tutor. Write a short answer on assuming a plain washer loc
Spot my mistake: Sectioning a shaft, a bolt or a rib along its length
Act as my SS3 Technical Drawing tutor. Write a short answer on sectioning a shaft, a bolt
Spot my mistake: Assuming cavalier and cabinet oblique use the same depth along the receding axis
Act as my SS3 Technical Drawing tutor. Write a short answer on assuming cavalier and cabin
Spot my mistake: Measuring the angle between two planes in a view where neither appears as an edge
Act as my SS3 Technical Drawing tutor. Write a short answer on measuring the angle between