296 prompts matching "Tension and compression members on a board sketch of a king post truss"
WAEC prep: Reading a third angle drawing correctly
Act as a WAEC/NECO Technical Drawing examiner. I am in SS 3. Set me five exam-style questi
Teach me: Why a line appears shorter than its true length
You are my personal SS3 Technical Drawing tutor. Teach me why a line appears shorter than
WAEC prep: The angle between two intersecting planes
Act as a WAEC/NECO Technical Drawing examiner. I am in SS 3. Set me five exam-style questi
Spot my mistake: Assuming a single set square will give every angle a drawing requires
Act as my SS3 Technical Drawing tutor. Write a short answer on assuming a single set squar
Spot my mistake: Using a chain line where a hidden edge should be shown
Act as my SS3 Technical Drawing tutor. Write a short answer on using a chain line where a
Spot my mistake: Treating an ellipse as a shape struck from four centres rather than plotted as a locus
Act as my SS3 Technical Drawing tutor. Write a short answer on treating an ellipse as a sh
Spot my mistake: Assuming every wall in a building carries load
Act as my SS3 Technical Drawing tutor. Write a short answer on assuming every wall in a bu
Spot my mistake: Reading a weld symbol below the reference line as though it sat above it
Act as my SS3 Technical Drawing tutor. Write a short answer on reading a weld symbol below
Spot my mistake: Assuming a plain washer locks a nut against loosening
Act as my SS3 Technical Drawing tutor. Write a short answer on assuming a plain washer loc
Spot my mistake: Assuming a line inclined in both views can have its true length measured in either
Act as my SS3 Technical Drawing tutor. Write a short answer on assuming a line inclined in
Spot my mistake: Measuring the angle between two planes in a view where neither appears as an edge
Act as my SS3 Technical Drawing tutor. Write a short answer on measuring the angle between
Let me explain: Dividing a line in a given ratio
I have just studied dividing a line in a given ratio in my SS3 Technical Drawing class. Le
Let me explain: Enlarging or reducing a figure by area
I have just studied enlarging or reducing a figure by area in my SS3 Technical Drawing cla
Let me explain: Drawing an isometric circle by the four-centre method
I have just studied drawing an isometric circle by the four-centre method in my SS3 Technical Drawing class. Let me explain it back to you in my own words, then tell me plainly what I got wrong or left out. Ask me one follow-up question afterwards to test whether I really understood it.
launch and paste in:
Let me explain: Setting up a two-point perspective
I have just studied setting up a two-point perspective in my SS3 Technical Drawing class.
Let me explain: Projecting a third view from two given views
I have just studied projecting a third view from two given views in my SS3 Technical Drawi