287 prompts matching "4. Construct a diagonal scale and use it to read to three units of measurement"
Teach me: How a second auxiliary view is used to obtain the true shape of a face inclined to both
You are my personal SS2 Technical Drawing tutor. Teach me how a second auxiliary view is u
Quiz: Producing an oblique (cabinet) drawing of the same block with the depth drawn at half scale
Quiz me on producing an oblique (cabinet) drawing of the same block with the depth drawn a
Practice set: Why layers, rather than a single drawing layer, are used for outline and hidden detail
Set me five practice tasks on why layers, rather than a single drawing layer, are used for
Spot my mistake: Constructing orthographic views of a truncated solid in AutoCAD
Show me a worked example on constructing orthographic views of a truncated solid in AutoCA
Teach me: Rotate the user coordinate system to produce an auxiliary elevation
You are my personal SS2 Technical Drawing tutor. Teach me rotate the user coordinate syste
Teach me: Examined with the command words state, describe and explain
I am an SS2 student studying Loci and Special Curves in Technical Drawing. Explain examine
Real-life Nigeria: Constructing an involute of a circle and a cycloid on one A3 sheet
Take constructing an involute of a circle and a cycloid on one A3 sheet out of the textboo
Spot my mistake: What happens to the output at a dead-centre position
Show me a worked example on what happens to the output at a dead-centre position with an e
Practice set: Out the standard layout on the board, moving the station point twice to show the distortion
Give me a practice set on out the standard layout on the board, moving the station point t
Quiz: Drawing a circle in perspective by enclosing it in a square and plotting eight points
Set me a quick recall test on drawing a circle in perspective by enclosing it in a square
Spot my mistake: Four line types used in orthographic drawing and the purpose of each
Show me a worked example on four line types used in orthographic drawing and the purpose o
Teach me: Add a sectional view on a stated cutting plane, hatched at 45 degrees, and label it A-A
I am an SS2 student studying Orthographic Projection III in Technical Drawing. Explain add
Project task: Autumn Term true-shape method and sets it beside the auxiliary method on the board
Set me a small project on autumn Term true-shape method and sets it beside the auxiliary m
Spot my mistake: Set up an AutoCAD drawing: units, limits
Give me a wrong or muddled explanation of set up an AutoCAD drawing: units, limits from th
Project task: LINE, OFFSET, TRIM and ELLIPSE commands on the projector
Give me a practical task on LINE, OFFSET, TRIM and ELLIPSE commands on the projector from
Practice set: What is meant by the first quadrant and why technical drawing works within it
Set me five practice tasks on what is meant by the first quadrant and why technical drawin
Teach me: By shape a trowel, plumb bob, spirit level, mason's square, float, bolster and jointer
I am an SS2 student studying Building Tools and Freehand Sketching in Technical Drawing. E
Let me explain: Drawing to a scale of 1:20 a section through a strip foundation
Act as my study partner. I will teach you drawing to a scale of 1:20 a section through a s
Real-life Nigeria: Lesson with the load path from roof to soil, drawing it as arrows on a board section
Take lesson with the load path from roof to soil, drawing it as arrows on a board section
Practice set: Examining photographs of local soils and foundations
Give me a practice set on examining photographs of local soils and foundations for SS2 Tec