228 prompts matching "Add a sectional view on a stated cutting plane, hatched at 45 degrees, and label"
WAEC prep: The two classifications of drawing, compared
Act as my WAEC Technical Drawing examiner. I am in SS1. Set me an exam-standard question o
WAEC prep: Success: sheet completed with correct pencil grade for outline, construction and dimension lines
Act as my WAEC Technical Drawing examiner. I am in SS1. Set me an exam-standard question o
Quiz: 2. Prepare a title block and border to standard proportions on a drawing sheet
Set me a quick recall test on 2. Prepare a title block and border to standard proportions
Project task: Layout of a title block on the board with proportions marked. Students draw a border
Give me a practical task on layout of a title block on the board with proportions marked.
Practice set: Preparing a title block to given proportions
Set me five practice tasks on preparing a title block to given proportions, at the level e
Spot my mistake: Producing vertical and inclined lettering to consistent height
Show me a worked example on producing vertical and inclined lettering to consistent height
Teach me: 1. Demonstrate safe handling of the drawing board, T-square and compass
Be my SS1 Technical Drawing teacher for this one point: 1. Demonstrate safe handling of th
Let me explain: 3. Demonstrate healthful habits: posture
Act as my study partner. I will teach you 3. Demonstrate healthful habits: posture in my o
Spot my mistake: 4. Apply studio rules consistently and maintain instruments in working order
Show me a worked example on 4. Apply studio rules consistently and maintain instruments in
Practice set: Demonstrating safe handling of board, T-square and compass
Set me five practice tasks on demonstrating safe handling of board, T-square and compass,
WAEC prep: Producing a hazard-and-control chart
Act as my WAEC Technical Drawing examiner. I am in SS1. Set me an exam-standard question o
Practice set: Success: assessed observation checklist passed on all five safety points
Set me five practice tasks on success: assessed observation checklist passed on all five s
WAEC prep: Success: division into seven parts accurate to within 0.5 mm across the whole line
Act as my WAEC Technical Drawing examiner. I am in SS1. Set me an exam-standard question o
Let me explain: 3. Construct the special angles 30°, 45°, 60°, 75°, 90°, 105° and 120° using compasses only
I am going to explain 3. Construct the special angles 30°, 45°, 60°, 75°, 90°, 105° and 12
Spot my mistake: 4. Construct any acute angle using the tangent and the sine methods, and bisect a given angle
Give me a wrong or muddled explanation of 4. Construct any acute angle using the tangent a
Practice set: Each construction step by step on the board. Students construct the full set of special angles
Give me a practice set on each construction step by step on the board. Students construct
Practice set: Constructing the special angles without a protractor
Set me five practice tasks on constructing the special angles without a protractor, at the
Spot my mistake: Success: every constructed angle within ±1° when checked with a protractor
Show me a worked example on success: every constructed angle within ±1° when checked with
Let me explain: 3. Construct a triangle given three sides
Act as my study partner. I will teach you 3. Construct a triangle given three sides in my
Teach me: Given one side and two angles
You are my personal SS1 Technical Drawing tutor. Teach me given one side and two angles, a