296 prompts matching "Let me explain: 1. State the purpose of drawing standards"
Let me explain: Abbreviations used on engineering drawings
I have just studied abbreviations used on engineering drawings in my SS3 Technical Drawing
Let me explain: Suspended timber floors and their members
I have just studied suspended timber floors and their members in my SS3 Technical Drawing
Let me explain: The strings, newel and balustrade
I have just studied the strings, newel and balustrade in my SS3 Technical Drawing class. L
Let me explain: The part or local section
I have just studied the part or local section in my SS3 Technical Drawing class. Let me ex
Let me explain: Converting a first angle drawing to third angle
I have just studied converting a first angle drawing to third angle in my SS3 Technical Dr
Spot my mistake: Reading the representative fraction as the ratio of the drawing to the sheet rather than to the object
Act as my SS3 Technical Drawing tutor. Write a short answer on reading the representative
Spot my mistake: Treating a chord and a diameter as interchangeable when finding the centre of an arc
Act as my SS3 Technical Drawing tutor. Write a short answer on treating a chord and a diam
Spot my mistake: Developing the curved surface of a cone as a rectangle of the same height
Act as my SS3 Technical Drawing tutor. Write a short answer on developing the curved surfa
Spot my mistake: Assuming the intersection of two equal cylinders meeting at right angles is always a curve
Act as my SS3 Technical Drawing tutor. Write a short answer on assuming the intersection o
Spot my mistake: Treating the resultant and the equilibrant of a force system as the same force
Act as my SS3 Technical Drawing tutor. Write a short answer on treating the resultant and
Spot my mistake: Placing the damp proof membrane beneath the hardcore in a solid floor
Act as my SS3 Technical Drawing tutor. Write a short answer on placing the damp proof memb
Spot my mistake: Treating the going and the tread of a stair as the same dimension
Act as my SS3 Technical Drawing tutor. Write a short answer on treating the going and the
Spot my mistake: Drawing the true helix of a screw thread rather than its conventional representation
Act as my SS3 Technical Drawing tutor. Write a short answer on drawing the true helix of a
Let me explain: Single stroke lettering and its proportions
I have just studied single stroke lettering and its proportions in my SS3 Technical Drawin
Let me explain: Dividing a line in a given ratio
I have just studied dividing a line in a given ratio in my SS3 Technical Drawing class. Le
Let me explain: Constructing a diagonal scale and reading it
I have just studied constructing a diagonal scale and reading it in my SS3 Technical Drawi
Let me explain: Constructing 30, 45 and 75 degree angles
I have just studied constructing 30, 45 and 75 degree angles in my SS3 Technical Drawing c
Let me explain: Constructing a regular polygon on a given side
I have just studied constructing a regular polygon on a given side in my SS3 Technical Dra
Let me explain: Constructing a circle through three given points
I have just studied constructing a circle through three given points in my SS3 Technical D
Let me explain: Internal and external common tangents to two circles
I have just studied internal and external common tangents to two circles in my SS3 Technical Drawing class. Let me explain it back to you in my own words, then tell me plainly what I got wrong or left out. Ask me one follow-up question afterwards to test whether I really understood it.
launch and paste in: