226 prompts matching "Comparing the CAD auxiliary with their Week 8 board drawing"
Spot my mistake: 4. Determine the linear ratio corresponding to a given ratio of areas
Show me a worked example on 4. Determine the linear ratio corresponding to a given ratio o
Project task: Why doubling the area of a square requires a side ratio of √2
Give me a practical task on why doubling the area of a square requires a side ratio of √2
Spot my mistake: Calculating the linear ratio from a given area ratio
Show me a worked example on calculating the linear ratio from a given area ratio with an e
WAEC prep: Success: all six diagram pairs correctly judged with a valid geometric reason for each
Act as my WAEC Technical Drawing examiner. I am in SS1. Set me an exam-standard question o
Practice set: Completing the four standard equal-area constructions on one sheet
Give me a practice set on completing the four standard equal-area constructions on one she
Spot my mistake: 1. State the principle of tangency and its applications
Show me a worked example on 1. State the principle of tangency and its applications with a
Project task: That the tangent is perpendicular to the radius at the point of contact. Students construct
Set me a small project on that the tangent is perpendicular to the radius at the point of
Practice set: Success: radius and tangent perpendicular within ±1° at every point of tangency
Set me five practice tasks on success: radius and tangent perpendicular within ±1° at ever
WAEC prep: Success: all blends visually smooth with tangency points marked and radii within 0.5 mm
Act as my WAEC Technical Drawing examiner. I am in SS1. Set me an exam-standard question o
Teach me: 2. Plot the locus of a point on a rotating and a sliding mechanism
Be my SS1 Technical Drawing teacher for this one point: 2. Plot the locus of a point on a
Practice set: Plotting the loci of a point at a fixed distance from a line
Give me a practice set on plotting the loci of a point at a fixed distance from a line for
Spot my mistake: Plotting the path of a point on a crank mechanism
Show me a worked example on plotting the path of a point on a crank mechanism with an erro
Teach me: Formal assessment of the second term programme of study
You are my personal SS1 Technical Drawing tutor. Teach me formal assessment of the second
Quiz: 1. Define and distinguish the ellipse, cycloid, trochoid, involute and helix
I am revising Special Curves for SS1 Technical Drawing. Test me on 1. Define and distingui
Spot my mistake: The meaning of the special curves
Show me a worked example on the meaning of the special curves with an error somewhere in i
Spot my mistake: The meaning of development and its applications
Show me a worked example on the meaning of development and its applications with an error
Practice set: Success: both folded models close with a gap of less than 2 mm
Set me five practice tasks on success: both folded models close with a gap of less than 2
Teach me: 1. Prepare the pattern development of a prism and of a cylinder
Be my SS1 Technical Drawing teacher for this one point: 1. Prepare the pattern development
Quiz: 2. Draw and interpret the first-angle and third-angle projection symbols
I am revising Orthographic Projection for SS1 Technical Drawing. Test me on 2. Draw and in
Real-life Nigeria: Dimensioning rules with examples of correct
Take dimensioning rules with examples of correct out of the textbook. Describe a real Nige