Technical Drawing

Write a short SS1 Technical Drawing answer about 4. Interpret a three-view orthographic dr

I am going to explain 3. Use construction layers to build up complex isometric shapes to y

Give me a wrong or muddled explanation of 4. Produce a finished isometric drawing of a com

Set me five practice tasks on producing a composite isometric drawing from orthographic vi

Be my SS1 Technical Drawing teacher for this one point: 2. Demonstrate the types of obliqu

Quiz me on 3. Construct an oblique drawing using the box method, from the SS1 Technical Dr

You are my personal SS1 Technical Drawing tutor. Teach me 2. Use a graphics package for le

I am revising Introduction to Computer Graphics and Cad for SS1 Technical Drawing. Test me

I am revising Drawing Materials and Equipment for SS1 Technical Drawing. Test me on 2. Dis

Give me a practice set on and names each item in a full drawing set for SS1 Technical Draw

Act as my WAEC Technical Drawing examiner. I am in SS1. Set me an exam-standard question o

Set me five practice tasks on preparing a title block to given proportions, at the level e

Show me a worked example on producing vertical and inclined lettering to consistent height

Set me five practice tasks on constructing the special angles without a protractor, at the

Show me a worked example on success: every constructed angle within ±1° when checked with

Set me a quick recall test on 4. Construct eccentric and concentric circles to given dimen

Take drawing a large circle and label all named parts out of the textbook. Describe a real

Set me five practice tasks on success: all ten circle parts correctly labelled and spacing

Show me a worked example on drawing and interpret both projection symbols with an error so

Show me a worked example on 4. Determine the linear ratio corresponding to a given ratio o