Technical Drawing

Quiz me on producing an oblique (cabinet) drawing of the same block with the depth drawn a

Set me five practice tasks on why layers, rather than a single drawing layer, are used for

Set me a quick recall test on locate points at stated distances above the HP at SS2 level.

Show me a worked example on why a line parallel to a plane appears in true length in the v

Take lesson with the load path from roof to soil, drawing it as arrows on a board section

Act as my WAEC Technical Drawing examiner. I am in SS2. Set me an exam-standard question o

Act as my study partner. I will teach you drawing the sectional elevation and plan of a do

Set me a small project on drawing the full detail to 1:10 on A3, annotate every layer, the

Give me a practice set on listing five machines seen locally that use linkages for SS2 Tec

I am revising True Shapes I for SS2 Technical Drawing. Test me on determine the true shape

Let me talk you through determine the true shape of a cylinder truncated by an oblique pla

Write a short SS2 Technical Drawing answer about the conic section produced by each of fou

Give me a practice set on modelling-clay cone at four angles in front of the class for SS2

I am going to explain determine the true shape of the cut face of a square pyramid truncat

Give me a practice set on one truncated hexagonal prism on the board for SS2 Technical Dra

Take swap sheets and mark each other's work against a three-point checklist out of the tex

Give me a practical task on set out the development of their Week 6 truncated cone on card

Give me a practical task on determine the intersection of a 30 mm square prism entering a

Set me a quick recall test on drawing a circle in perspective by enclosing it in a square

I am going to explain rendering the finished view with tone and texture to distinguish two