296 prompts matching "Let me explain: Drawing to 1:10 the elevation and horizontal section of a caseme"
Let me explain: Plumbing symbols and pipe runs
I have just studied plumbing symbols and pipe runs in my SS3 Technical Drawing class. Let
Let me explain: Representing timber, insulation and hardcore
I have just studied representing timber, insulation and hardcore in my SS3 Technical Drawi
Let me explain: Reading weld size and length from a symbol
I have just studied reading weld size and length from a symbol in my SS3 Technical Drawing
Let me explain: Clearance, interference and transition fits
I have just studied clearance, interference and transition fits in my SS3 Technical Drawin
Let me explain: Bolts, studs and set screws
I have just studied bolts, studs and set screws in my SS3 Technical Drawing class. Let me
Let me explain: Spring washers and tab washers
I have just studied spring washers and tab washers in my SS3 Technical Drawing class. Let
Let me explain: Removed and revolved sections
I have just studied removed and revolved sections in my SS3 Technical Drawing class. Let m
Let me explain: Oblique circles and curves
I have just studied oblique circles and curves in my SS3 Technical Drawing class. Let me e
Let me explain: Setting up a two-point perspective
I have just studied setting up a two-point perspective in my SS3 Technical Drawing class.
Let me explain: Projecting a third view from two given views
I have just studied projecting a third view from two given views in my SS3 Technical Drawi
Let me explain: Finding true length by auxiliary projection
I have just studied finding true length by auxiliary projection in my SS3 Technical Drawin
Spot my mistake: Reading the representative fraction as the ratio of the drawing to the sheet rather than to the object
Act as my SS3 Technical Drawing tutor. Write a short answer on reading the representative
Spot my mistake: Drawing a tangent that meets the radius at the point of contact at any convenient angle
Act as my SS3 Technical Drawing tutor. Write a short answer on drawing a tangent that meet
Spot my mistake: Treating isometric drawing and true isometric projection as giving a view of the same size
Act as my SS3 Technical Drawing tutor. Write a short answer on treating isometric drawing
Practice set: Drawing one object in all three pictorial methods
Act as my SS3 Technical Drawing tutor. Give me five practice questions on drawing one obje
Teach me: The bricklayer's tools and their uses
You are my personal SS3 Technical Drawing tutor. Teach me the bricklayer's tools and their
Teach me: The fitter's hand tools and their uses
You are my personal SS3 Technical Drawing tutor. Teach me the fitter's hand tools and thei
Teach me: How the object sits relative to the planes in first angle
You are my personal SS3 Technical Drawing tutor. Teach me how the object sits relative to
Spot my mistake: Dividing a line into equal parts by measuring with a rule instead of by construction
Act as my SS3 Technical Drawing tutor. Write a short answer on dividing a line into equal
Spot my mistake: Treating a chord and a diameter as interchangeable when finding the centre of an arc
Act as my SS3 Technical Drawing tutor. Write a short answer on treating a chord and a diam