228 prompts matching "Let me explain: Sketching freehand front, top and side views of two of the same"
Spot my mistake: Calculating interior and exterior angles for three named polygons
Show me a worked example on calculating interior and exterior angles for three named polyg
Spot my mistake: 4. Verify the accuracy of an enlargement by measurement and calculation
Write a short SS1 Technical Drawing answer about 4. Verify the accuracy of an enlargement
Spot my mistake: Consolidation of polygons, scales, enlargement and reduction, equal areas, tangency and loci
Show me a worked example on consolidation of polygons, scales, enlargement and reduction,
Spot my mistake: The meaning of development and its applications
Show me a worked example on the meaning of development and its applications with an error
Spot my mistake: 4. Produce models of geometrical solids from their developments and evaluate accuracy
Show me a worked example on 4. Produce models of geometrical solids from their development
Spot my mistake: Preparing developments of prisms and cylinders and develop models of geometrical solids
Show me a worked example on preparing developments of prisms and cylinders and develop mod
Spot my mistake: 1. Explain what CAD is and compare CAD with manual drawing for accuracy, revision and storage
Show me a worked example on 1. Explain what CAD is and compare CAD with manual drawing for
Spot my mistake: Success: a correctly named and exported file produced that matches the manual drawing
Show me a worked example on success: a correctly named and exported file produced that mat
Quiz: 2. Distinguish between drawing materials and drawing instruments
I am revising Drawing Materials and Equipment for SS1 Technical Drawing. Test me on 2. Dis
Practice set: And names each item in a full drawing set
Give me a practice set on and names each item in a full drawing set for SS1 Technical Draw
Teach me: 1. Demonstrate safe handling of the drawing board, T-square and compass
Be my SS1 Technical Drawing teacher for this one point: 1. Demonstrate safe handling of th
Spot my mistake: 4. Construct any acute angle using the tangent and the sine methods, and bisect a given angle
Give me a wrong or muddled explanation of 4. Construct any acute angle using the tangent a
Teach me: 3. Distinguish eccentric from concentric circles and illustrate each
I am an SS1 student studying Circles and Triangles I in Technical Drawing. Explain 3. Dist
Real-life Nigeria: Drawing a large circle and label all named parts
Take drawing a large circle and label all named parts out of the textbook. Describe a real
Teach me: 3. Describe an escribed circle and construct one to a given triangle
Be my SS1 Technical Drawing teacher for this one point: 3. Describe an escribed circle and
Teach me: 3. Interpret and apply the first-angle and third-angle projection symbols
I am an SS1 student studying Drawing Standards and Conventions in Technical Drawing. Expla
WAEC prep: Five standard abbreviations with meanings
Act as my WAEC Technical Drawing examiner. I am in SS1. Set me an exam-standard question o
Spot my mistake: 4. Construct a diagonal scale and use it to read to three units of measurement
Give me a wrong or muddled explanation of 4. Construct a diagonal scale and use it to read
Teach me: 1. Describe the concept of enlargement and reduction of a plane figure
Be my SS1 Technical Drawing teacher for this one point: 1. Describe the concept of enlarge
Quiz: 2. Distinguish between enlargement by ratio of sides and by ratio of areas
Quiz me on 2. Distinguish between enlargement by ratio of sides and by ratio of areas, fro