Technical Drawing

Quiz me on 2. Distinguish between enlargement by ratio of sides and by ratio of areas, fro

Write a short SS1 Technical Drawing answer about 4. Verify the accuracy of an enlargement

I am going to explain 4. Blend arcs and lines smoothly, marking all points of tangency to

Show me a worked example on plotting the path of a point on a crank mechanism with an erro

I am going to explain 3. Determine true lengths of the edges of full and truncated solids

Be my SS1 Technical Drawing teacher for this one point: 1. Prepare the pattern development

Quiz me on 2. Prepare the development of truncated prisms and cylinders, from the SS1 Tech

I am an SS1 student studying Methods of Dimensioning in Technical Drawing. Explain 1. Stat

You are my personal SS1 Technical Drawing tutor. Teach me 1. Construct isometric squares a

Set me five practice tasks on constructing isometric squares, rectangles, arcs and circles

Give me a practice set on cavalier and cabinet oblique of the same block so students can s

I am revising Drawing Materials and Equipment for SS1 Technical Drawing. Test me on 2. Dis

Give me a practice set on and names each item in a full drawing set for SS1 Technical Draw

Show me a worked example on producing vertical and inclined lettering to consistent height

Set me a quick recall test on 2. Identify the types of angles: acute, right, obtuse, refle

Show me a worked example on given two sides and the included angle with an error somewhere

Show me a worked example on success: all three constructions within 0.5 mm and ±1° of the

Show me a worked example on constructing an inscribed, a circumscribed and an escribed cir

Write a short SS1 Technical Drawing answer about 2. Identify standard line types and their

Show me a worked example on drawing and interpret both projection symbols with an error so