296 prompts matching "Quiz: 2. Place dimensions on circles, arcs and chamfers"
Quiz: Types of window and where each is used
Act as my SS3 Technical Drawing tutor and quiz me on types of window and where each is use
Practice set: Setting out a straight flight to given dimensions
Act as my SS3 Technical Drawing tutor. Give me five practice questions on setting out a st
Quiz: Lean-to, gable and hipped roofs
Act as my SS3 Technical Drawing tutor and quiz me on lean-to, gable and hipped roofs. Ask
Quiz: Fillet and butt weld symbols
Act as my SS3 Technical Drawing tutor and quiz me on fillet and butt weld symbols. Ask fiv
Quiz: Upper and lower limits of size
Act as my SS3 Technical Drawing tutor and quiz me on upper and lower limits of size. Ask f
Quiz: Metric, square and acme thread forms
Act as my SS3 Technical Drawing tutor and quiz me on metric, square and acme thread forms.
Quiz: Lock nuts and castle nuts
Act as my SS3 Technical Drawing tutor and quiz me on lock nuts and castle nuts. Ask five q
Quiz: The half section on a symmetrical part
Act as my SS3 Technical Drawing tutor and quiz me on the half section on a symmetrical par
Quiz: The broken-out section
Act as my SS3 Technical Drawing tutor and quiz me on the broken-out section. Ask five ques
Quiz: Isometric drawing against true isometric projection
Act as my SS3 Technical Drawing tutor and quiz me on isometric drawing against true isomet
Let me explain: Oblique circles and curves
I have just studied oblique circles and curves in my SS3 Technical Drawing class. Let me e
Quiz: Setting up a one-point perspective
Act as my SS3 Technical Drawing tutor and quiz me on setting up a one-point perspective. A
Quiz: The position of views in third angle
Act as my SS3 Technical Drawing tutor and quiz me on the position of views in third angle.
Quiz: Finding true length by rotation
Act as my SS3 Technical Drawing tutor and quiz me on finding true length by rotation. Ask
Quiz: The centroid of a rectangle and a triangle
Act as my SS3 Technical Drawing tutor and quiz me on the centroid of a rectangle and a tri
Spot my mistake: Assuming a polygon constructed on a given side will also fit a given circle
Act as my SS3 Technical Drawing tutor. Write a short answer on assuming a polygon construc
Spot my mistake: Dimensioning every part fully on an assembly drawing
Act as my SS3 Technical Drawing tutor. Write a short answer on dimensioning every part ful
Let me explain: Single stroke lettering and its proportions
I have just studied single stroke lettering and its proportions in my SS3 Technical Drawin
Teach me: What a scale is and how the representative fraction works
You are my personal SS3 Technical Drawing tutor. Teach me what a scale is and how the repr
Let me explain: Constructing a diagonal scale and reading it
I have just studied constructing a diagonal scale and reading it in my SS3 Technical Drawi