287 prompts matching "Quiz: 2. Place dimensions on circles, arcs and chamfers"
Quiz: Two common errors in auxiliary projection of truncated solids
Set me a quick recall test on two common errors in auxiliary projection of truncated solid
Let me explain: Assessed AO3, and truncated solids in auxiliary projection are frequent in WAEC and NECO Paper 2
I am going to explain assessed AO3, and truncated solids in auxiliary projection are frequ
Project task: Autumn Term true-shape method and sets it beside the auxiliary method on the board
Set me a small project on autumn Term true-shape method and sets it beside the auxiliary m
Project task: LINE, OFFSET, TRIM and ELLIPSE commands on the projector
Give me a practical task on LINE, OFFSET, TRIM and ELLIPSE commands on the projector from
Spot my mistake: Producing and plot an isometric drawing of a given block at 1:1 on A3
Show me a worked example on producing and plot an isometric drawing of a given block at 1:
WAEC prep: Four advantages and two limitations of CAD compared with drawing-board work
Act as my WAEC Technical Drawing examiner. I am in SS2. Set me an exam-standard question o
Practice set: Rotating the UCS and setting up a viewport so the auxiliary direction becomes horizontal on
Give me a practice set on rotating the UCS and setting up a viewport so the auxiliary dire
Spot my mistake: The meaning of the horizontal plane, the vertical plane and the reference line XY
Write a short SS2 Technical Drawing answer about the meaning of the horizontal plane, the
Let me explain: Determine the horizontal trace and vertical trace of a line inclined to both planes
I am going to explain determine the horizontal trace and vertical trace of a line inclined
Real-life Nigeria: Are given a plan and elevation only and must state the position of each point in words
Show me how are given a plan and elevation only and must state the position of each point
Spot my mistake: Drawing the plan and elevation of five points at stated distances above the HP
Show me a worked example on drawing the plan and elevation of five points at stated distan
WAEC prep: Determine the horizontal and vertical traces of a line given its plan and elevation
Act as my WAEC Technical Drawing examiner. I am in SS2. Set me an exam-standard question o
Let me explain: Determine the true inclination of the line to the horizontal plane and to the vertical plane
Act as my study partner. I will teach you determine the true inclination of the line to th
Practice set: Rod at an angle to both card planes and rotates it into a position parallel to the VP so the
Give me a practice set on rod at an angle to both card planes and rotates it into a positi
Practice set: Card triangle in the two-plane model and turns it until the class sees it edge-on
Give me a practice set on card triangle in the two-plane model and turns it until the clas
Teach me: By shape a trowel, plumb bob, spirit level, mason's square, float, bolster and jointer
I am an SS2 student studying Building Tools and Freehand Sketching in Technical Drawing. E
Let me explain: Sketching freehand front, top and side views of two of the same tools
I am going to explain sketching freehand front, top and side views of two of the same tool
Real-life Nigeria: Real building tools, names each and passes them round so students feel proportion
Show me how real building tools, names each and passes them round so students feel proport
Practice set: Practising crating and proportion exercises
Give me a practice set on practising crating and proportion exercises for SS2 Technical Dr
Practice set: Sketching freehand, in pictorial view, four building tools in correct proportion within twenty
Set me five practice tasks on sketching freehand, in pictorial view, four building tools i