228 prompts matching "The projection symbols and reading them"
Spot my mistake: 4. Divide a straight line into any number of equal segments and into a given ratio
Write a short SS1 Technical Drawing answer about 4. Divide a straight line into any number
Practice set: Constructing the special angles without a protractor
Set me five practice tasks on constructing the special angles without a protractor, at the
Spot my mistake: 2. Draw a circle and label its parts correctly
Write a short SS1 Technical Drawing answer about 2. Draw a circle and label its parts corr
Practice set: Success: all ten circle parts correctly labelled and spacings accurate to 0.5 mm
Set me five practice tasks on success: all ten circle parts correctly labelled and spacing
Quiz: 4. Construct any quadrilateral when four sides and one diagonal are known
I am revising Quadrilaterals for SS1 Technical Drawing. Test me on 4. Construct any quadri
Practice set: The types of quadrilaterals with their properties
Set me five practice tasks on the types of quadrilaterals with their properties, at the le
Practice set: Sheet sizes and line types
Set me five practice tasks on sheet sizes and line types, at the level expected in SS1 Dra
Quiz: 2. Construct a regular polygon using the circle (circumscribing) method
I am revising Polygons II for SS1 Technical Drawing. Test me on 2. Construct a regular pol
Spot my mistake: 4. Compare the three methods for accuracy
Write a short SS1 Technical Drawing answer about 4. Compare the three methods for accuracy
Practice set: Success: five dimensions set off from the diagonal scale correct within 0.5 mm
Set me five practice tasks on success: five dimensions set off from the diagonal scale cor
Practice set: Success: radius and tangent perpendicular within ±1° at every point of tangency
Set me five practice tasks on success: radius and tangent perpendicular within ±1° at ever
Spot my mistake: 3. Construct a cycloid and a trochoid from a rolling circle
Write a short SS1 Technical Drawing answer about 3. Construct a cycloid and a trochoid fro
WAEC prep: Success: all three views correctly aligned by projection
Act as my WAEC Technical Drawing examiner. I am in SS1. Set me an exam-standard question o
Practice set: Dimension circles, arcs, chamfers and vertical, horizontal and angular shapes correctly
Set me five practice tasks on dimension circles, arcs, chamfers and vertical, horizontal a
Practice set: Constructing isometric squares, rectangles, arcs and circles
Set me five practice tasks on constructing isometric squares, rectangles, arcs and circles
Quiz: 3. Use a graphics package to produce plane and pictorial figures
I am revising Introduction to Computer Graphics and Cad for SS1 Technical Drawing. Test me
Practice set: Portfolio and board accuracy recorded separately
Set me five practice tasks on portfolio and board accuracy recorded separately, at the lev
Let me explain: 3. State the advantages of CADD over manual drawing
Let me talk you through 3. State the advantages of CADD over manual drawing from the Drawi
Practice set: And names each item in a full drawing set
Give me a practice set on and names each item in a full drawing set for SS1 Technical Draw
WAEC prep: The two classifications of drawing, compared
Act as my WAEC Technical Drawing examiner. I am in SS1. Set me an exam-standard question o