Technical Drawing

Act as my WAEC Technical Drawing examiner. I am in SS1. Set me an exam-standard question o

Let me talk you through 4. Construct common tangents to two equal and to two unequal circl

Let me talk you through 3. Construct a regular polygon using the diagonal method from the

I am going to explain 3. Explain why triangles on the same base and between the same paral

I am going to explain 4. Blend arcs and lines smoothly, marking all points of tangency to

Let me talk you through 2. Construct an ellipse by the four-centre, concentric-circles and

Set me five practice tasks on two advantages of CADD, at the level expected in SS1 Drawing

Set me a quick recall test on 2. Prepare a title block and border to standard proportions

Set me five practice tasks on demonstrating safe handling of board, T-square and compass,

Write a short SS1 Technical Drawing answer about 4. Divide a straight line into any number

Show me how each line type against the standard line chart. Students produce a reference s

I am going to explain 3. Construct the special angles 30°, 45°, 60°, 75°, 90°, 105° and 12

Give me a wrong or muddled explanation of 4. Construct any acute angle using the tangent a

Take drawing a large circle and label all named parts out of the textbook. Describe a real

You are my personal SS1 Technical Drawing tutor. Teach me 3. Construct the special quadril

You are my personal SS1 Technical Drawing tutor. Teach me 1. Construct a regular polygon u

Give me a wrong or muddled explanation of 4. Construct a diagonal scale and use it to read

Quiz me on 2. Distinguish between enlargement by ratio of sides and by ratio of areas, fro

Give me a wrong or muddled explanation of 4. Identify the constructions used to transfer a

Write a short SS1 Technical Drawing answer about 1. Construct an arc of given radius inter