Technical Drawing

Show me a worked example on success: all three constructions within 0.5 mm and ±1° of the

Set me five practice tasks on success: all ten circle parts correctly labelled and spacing

Show me a worked example on 2. State the properties of each type of quadrilateral with an

Set me five practice tasks on the types of quadrilaterals with their properties, at the le

Write a short SS1 Technical Drawing answer about 2. Identify standard line types and their

Show me a worked example on drawing and interpret both projection symbols with an error so

Give me a wrong or muddled explanation of formal assessment of the first term programme of

Set me five practice tasks on accuracy of construction assessed separately from knowledge,

Show me a worked example on 4. Calculate the interior and exterior angles of any regular p

Set me a quick recall test on 2. Identify the types of scales: plain, diagonal, comparativ

Give me a wrong or muddled explanation of 4. Construct a diagonal scale and use it to read

Set me five practice tasks on success: five dimensions set off from the diagonal scale cor

Show me a worked example on 4. Determine the linear ratio corresponding to a given ratio o

Set me five practice tasks on enlarge and reduce plane figures based on the ratio of areas

Show me a worked example on success: every corresponding side within 1% of the calculated

Set me a quick recall test on 2. State the principles of converting the shape of a plane f

Set me five practice tasks on demonstrating and carry out the construction of plane figure

Show me a worked example on success: calculated areas of original and converted figures ag

Show me a worked example on 1. State the principle of tangency and its applications with a

Set me a small project on that the tangent is perpendicular to the radius at the point of