228 prompts matching "Let me explain: The angle of inclination of a line to a plane"
Spot my mistake: Given two sides and the included angle
Show me a worked example on given two sides and the included angle with an error somewhere
Spot my mistake: Success: all three constructions within 0.5 mm and ±1° of the specified data
Show me a worked example on success: all three constructions within 0.5 mm and ±1° of the
Spot my mistake: 2. State the properties of each type of quadrilateral
Show me a worked example on 2. State the properties of each type of quadrilateral with an
Spot my mistake: 2. Identify standard line types and their applications as set out in the drawing standard
Write a short SS1 Technical Drawing answer about 2. Identify standard line types and their
Spot my mistake: Calculating the linear ratio from a given area ratio
Show me a worked example on calculating the linear ratio from a given area ratio with an e
Spot my mistake: Success: every corresponding side within 1% of the calculated length
Show me a worked example on success: every corresponding side within 1% of the calculated
Spot my mistake: 1. State the principle of tangency and its applications
Show me a worked example on 1. State the principle of tangency and its applications with a
WAEC prep: The two classifications of drawing, compared
Act as my WAEC Technical Drawing examiner. I am in SS1. Set me an exam-standard question o
Project task: Layout of a title block on the board with proportions marked. Students draw a border
Give me a practical task on layout of a title block on the board with proportions marked.
Spot my mistake: Producing vertical and inclined lettering to consistent height
Show me a worked example on producing vertical and inclined lettering to consistent height
Quiz: 2. Produce lines with the correct weights
I am revising Lines and Line Work for SS1 Technical Drawing. Test me on 2. Produce lines w
Real-life Nigeria: Each line type against the standard line chart. Students produce a reference sheet showing all
Show me how each line type against the standard line chart. Students produce a reference s
WAEC prep: Success: division into seven parts accurate to within 0.5 mm across the whole line
Act as my WAEC Technical Drawing examiner. I am in SS1. Set me an exam-standard question o
Teach me: 1. Define an angle
I am an SS1 student studying Angles and Triangles I in Technical Drawing. Explain 1. Defin
Quiz: 4. Construct a triangle equal in area to a given quadrilateral and locate the centroid
I am revising Angles and Triangles II for SS1 Technical Drawing. Test me on 4. Construct a
Practice set: Constructing triangles from all three sets of given data
Set me five practice tasks on constructing triangles from all three sets of given data, at
Spot my mistake: Calculating interior and exterior angles for three named polygons
Show me a worked example on calculating interior and exterior angles for three named polyg
Spot my mistake: 4. Compare the three methods for accuracy
Write a short SS1 Technical Drawing answer about 4. Compare the three methods for accuracy
Teach me: 2. Construct a rectangle equal in area to a given triangle
Be my SS1 Technical Drawing teacher for this one point: 2. Construct a rectangle equal in
Teach me: 2. Construct an arc of given radius externally enclosing two circles
I am an SS1 student studying Tangents and Tangency II in Technical Drawing. Explain 2. Con