296 prompts matching "The difference between the trace of a line and the trace of a plane"
WAEC prep: The centroid of a figure with a cut-out
Act as a WAEC/NECO Technical Drawing examiner. I am in SS 3. Set me five exam-style questi
Practice set: Locating the centre of gravity of a given lamina
Act as my SS3 Technical Drawing tutor. Give me five practice questions on locating the cen
Spot my mistake: Reading the representative fraction as the ratio of the drawing to the sheet rather than to the object
Act as my SS3 Technical Drawing tutor. Write a short answer on reading the representative
Spot my mistake: Drawing a tangent that meets the radius at the point of contact at any convenient angle
Act as my SS3 Technical Drawing tutor. Write a short answer on drawing a tangent that meet
Spot my mistake: Hatching the whole sectional view rather than only what the cutting plane passes through
Act as my SS3 Technical Drawing tutor. Write a short answer on hatching the whole sectiona
Spot my mistake: Developing the curved surface of a cone as a rectangle of the same height
Act as my SS3 Technical Drawing tutor. Write a short answer on developing the curved surfa
Spot my mistake: Assuming the intersection of two equal cylinders meeting at right angles is always a curve
Act as my SS3 Technical Drawing tutor. Write a short answer on assuming the intersection o
Spot my mistake: Treating a tolerance as the error the workshop is expected to make rather than the permitted range of size
Act as my SS3 Technical Drawing tutor. Write a short answer on treating a tolerance as the
Spot my mistake: Placing the damp proof membrane beneath the hardcore in a solid floor
Act as my SS3 Technical Drawing tutor. Write a short answer on placing the damp proof memb
Spot my mistake: Reading a weld symbol below the reference line as though it sat above it
Act as my SS3 Technical Drawing tutor. Write a short answer on reading a weld symbol below
Spot my mistake: Drawing the true helix of a screw thread rather than its conventional representation
Act as my SS3 Technical Drawing tutor. Write a short answer on drawing the true helix of a
Spot my mistake: Assuming a line inclined in both views can have its true length measured in either
Act as my SS3 Technical Drawing tutor. Write a short answer on assuming a line inclined in
Teach me: The A2 ISO drawing board and how the sheet is fixed to it
You are my personal SS3 Technical Drawing tutor. Teach me the A2 ISO drawing board and how
Quiz: The T-square and set squares and the angles they give
Act as my SS3 Technical Drawing tutor and quiz me on the T-square and set squares and the
Let me explain: Compasses, dividers and the protractor
I have just studied compasses, dividers and the protractor in my SS3 Technical Drawing cla
Teach me: What a scale is and how the representative fraction works
You are my personal SS3 Technical Drawing tutor. Teach me what a scale is and how the repr
Let me explain: The escribed circle and how it is constructed
I have just studied the escribed circle and how it is constructed in my SS3 Technical Draw
WAEC prep: The cycloid, involute and helix
Act as a WAEC/NECO Technical Drawing examiner. I am in SS 3. Set me five exam-style questi
Teach me: The isometric axes and how a solid is set out on them
You are my personal SS3 Technical Drawing tutor. Teach me the isometric axes and how a sol
Quiz: Oblique projection and the receding axis
Act as my SS3 Technical Drawing tutor and quiz me on oblique projection and the receding a