Technical Drawing

Quiz me on 2. Distinguish between enlargement by ratio of sides and by ratio of areas, fro

You are my personal SS1 Technical Drawing tutor. Teach me 1. Enlarge a given plane figure

I am revising Enlargement and Reduction II for SS1 Technical Drawing. Test me on 2. Reduce

I am going to explain 3. Explain why triangles on the same base and between the same paral

Give me a wrong or muddled explanation of 4. Identify the constructions used to transfer a

Set me five practice tasks on success: radius and tangent perpendicular within ±1° at ever

Write a short SS1 Technical Drawing answer about 1. Construct an arc of given radius inter

I am an SS1 student studying Tangents and Tangency II in Technical Drawing. Explain 2. Con

Set me a quick recall test on 3. Construct an arc touching one circle internally and enclo

I am going to explain 4. Blend arcs and lines smoothly, marking all points of tangency to

Take work through the three arc-tangency cases from given data out of the textbook. Descri

Act as my study partner. I will teach you 4. Relate loci to the motion produced by levers,

Let me talk you through 2. Construct an ellipse by the four-centre, concentric-circles and

Set me five practice tasks on success: both folded models close with a gap of less than 2

Act as my study partner. I will teach you 3. Develop the pattern for a transition piece be

Set me a small project on three views of a stepped block from a physical model, the kind I

Give me a wrong or muddled explanation of 4. Distinguish chain, parallel and running dimen

Take dimensioning rules with examples of correct out of the textbook. Describe a real Nige

Give me a wrong or muddled explanation of 4. Produce a finished isometric drawing of a com

Act as my study partner. I will teach you 4. Construct an oblique drawing using the centre