Technical Drawing

Write a short SS1 Technical Drawing answer about 2. Draw a circle and label its parts corr

Set me five practice tasks on success: all ten circle parts correctly labelled and spacing

Act as my WAEC Technical Drawing examiner. I am in SS1. Set me an exam-standard question o

Set me five practice tasks on accuracy of construction assessed separately from knowledge,

Let me talk you through 3. Construct a regular polygon using the diagonal method from the

Give me a wrong or muddled explanation of 4. Construct a diagonal scale and use it to read

Quiz me on 2. Distinguish between enlargement by ratio of sides and by ratio of areas, fro

You are my personal SS1 Technical Drawing tutor. Teach me 1. Enlarge a given plane figure

I am revising Enlargement and Reduction II for SS1 Technical Drawing. Test me on 2. Reduce

I am going to explain 3. Explain why triangles on the same base and between the same paral

Give me a wrong or muddled explanation of 4. Identify the constructions used to transfer a

Set me five practice tasks on success: radius and tangent perpendicular within ±1° at ever

Write a short SS1 Technical Drawing answer about 1. Construct an arc of given radius inter

I am an SS1 student studying Tangents and Tangency II in Technical Drawing. Explain 2. Con

Set me a quick recall test on 3. Construct an arc touching one circle internally and enclo

I am going to explain 4. Blend arcs and lines smoothly, marking all points of tangency to

Take work through the three arc-tangency cases from given data out of the textbook. Descri

Act as my study partner. I will teach you 4. Relate loci to the motion produced by levers,

Let me talk you through 2. Construct an ellipse by the four-centre, concentric-circles and

Set me five practice tasks on success: both folded models close with a gap of less than 2