205 prompts matching "Drawing a bending moment diagram for a cantilever"
Practice set: Four-centre ellipse inside an isometric rhombus. Students construct isometric circles in the
Give me a practice set on four-centre ellipse inside an isometric rhombus. Students constr
Practice set: Constructing isometric squares, rectangles, arcs and circles
Set me five practice tasks on constructing isometric squares, rectangles, arcs and circles
Practice set: Cavalier and cabinet oblique of the same block so students can see the halved receding depth.
Give me a practice set on cavalier and cabinet oblique of the same block so students can s
Practice set: Success: cabinet oblique drawn with receding dimensions correctly halved
Set me five practice tasks on success: cabinet oblique drawn with receding dimensions corr
Quiz: 3. Use a graphics package to produce plane and pictorial figures
I am revising Introduction to Computer Graphics and Cad for SS1 Technical Drawing. Test me
Spot my mistake: Producing a sheet using at least five instruments correctly
Show me a worked example on producing a sheet using at least five instruments correctly wi
Let me explain: 3. Describe the purpose of lettering
I am going to explain 3. Describe the purpose of lettering to you, as an SS1 Technical Dra
Project task: Layout of a title block on the board with proportions marked. Students draw a border
Give me a practical task on layout of a title block on the board with proportions marked.
Practice set: Preparing a title block to given proportions
Set me five practice tasks on preparing a title block to given proportions, at the level e
Spot my mistake: Producing vertical and inclined lettering to consistent height
Show me a worked example on producing vertical and inclined lettering to consistent height
Spot my mistake: 4. Apply studio rules consistently and maintain instruments in working order
Show me a worked example on 4. Apply studio rules consistently and maintain instruments in
Spot my mistake: Practise healthy habits
Show me a worked example on practise healthy habits with an error somewhere in it. Do not
WAEC prep: Producing a hazard-and-control chart
Act as my WAEC Technical Drawing examiner. I am in SS1. Set me an exam-standard question o
Let me explain: 3. Draw parallel and perpendicular lines using T-square and set squares
Let me talk you through 3. Draw parallel and perpendicular lines using T-square and set sq
Spot my mistake: 4. Divide a straight line into any number of equal segments and into a given ratio
Write a short SS1 Technical Drawing answer about 4. Divide a straight line into any number
Real-life Nigeria: Each line type against the standard line chart. Students produce a reference sheet showing all
Show me how each line type against the standard line chart. Students produce a reference s
Spot my mistake: And produce all six line types at correct weight
Show me a worked example on and produce all six line types at correct weight with an error
WAEC prep: Success: division into seven parts accurate to within 0.5 mm across the whole line
Act as my WAEC Technical Drawing examiner. I am in SS1. Set me an exam-standard question o
Let me explain: 3. Construct the special angles 30°, 45°, 60°, 75°, 90°, 105° and 120° using compasses only
I am going to explain 3. Construct the special angles 30°, 45°, 60°, 75°, 90°, 105° and 12
Practice set: Constructing the special angles without a protractor
Set me five practice tasks on constructing the special angles without a protractor, at the