287 prompts matching "Let me explain: The escribed circle and how it is constructed"
WAEC prep: Determine the horizontal and vertical traces of a line given its plan and elevation
Act as my WAEC Technical Drawing examiner. I am in SS2. Set me an exam-standard question o
Practice set: Rod at an angle to both card planes and rotates it into a position parallel to the VP so the
Give me a practice set on rod at an angle to both card planes and rotates it into a positi
Real-life Nigeria: Measuring a real diagonal brace in the workshop or on a desk frame
Take measuring a real diagonal brace in the workshop or on a desk frame out of the textboo
Practice set: Card triangle in the two-plane model and turns it until the class sees it edge-on
Give me a practice set on card triangle in the two-plane model and turns it until the clas
WAEC prep: The difference between the trace of a line and the trace of a plane
Act as my WAEC Technical Drawing examiner. I am in SS2. Set me an exam-standard question o
Real-life Nigeria: Measuring openings in the school buildings
Take measuring openings in the school buildings out of the textbook. Describe a real Niger
WAEC prep: Why an arch is built with an odd number of voussoirs and a keystone at the crown
Act as my WAEC Technical Drawing examiner. I am in SS2. Set me an exam-standard question o
Practice set: Detail on the board one layer at a time
Give me a practice set on detail on the board one layer at a time for SS2 Technical Drawin
Practice set: Tension and compression members on a board sketch of a king post truss
Give me a practice set on tension and compression members on a board sketch of a king post
Quiz: The parabola, hyperbola, involute and cycloid by the defining condition of each, compared
I am revising Loci and Special Curves for SS2 Technical Drawing. Test me on the parabola,
Project task: Twelve-position method on the board, stressing that each crank position gives one new position
Set me a small project on twelve-position method on the board, stressing that each crank p
Teach me: Assessed AO3, and true shapes of truncated solids are a standing WAEC and NECO question
I am an SS2 student studying True Shapes I in Technical Drawing. Explain assessed AO3, and
Project task: Set out the development of their Week 6 truncated cone on card
Give me a practical task on set out the development of their Week 6 truncated cone on card
Project task: Drawing two cylinders of 50 mm and 30 mm diameter meeting at 90 degrees
Set me a small project on drawing two cylinders of 50 mm and 30 mm diameter meeting at 90
Practice set: The completed card assembly
Set me five practice tasks on the completed card assembly, at the level expected in SS2 In
Quiz: Drawing a circle in perspective by enclosing it in a square and plotting eight points
Set me a quick recall test on drawing a circle in perspective by enclosing it in a square
Project task: Card box round a small block to show the three planes opening out into the three views
Give me a practical task on card box round a small block to show the three planes opening
Project task: Up a poorly dimensioned drawing on the board
Set me a small project on up a poorly dimensioned drawing on the board, the kind I could f
Teach me: Add a sectional view on a stated cutting plane, hatched at 45 degrees, and label it A-A
I am an SS2 student studying Orthographic Projection III in Technical Drawing. Explain add
Project task: LINE, OFFSET, TRIM and ELLIPSE commands on the projector
Give me a practical task on LINE, OFFSET, TRIM and ELLIPSE commands on the projector from