Technical Drawing

Give me a practice set on and names each item in a full drawing set for SS1 Technical Draw

Set me five practice tasks on preparing a title block to given proportions, at the level e

Set me five practice tasks on success: assessed observation checklist passed on all five s

I am going to explain 3. Construct the special angles 30°, 45°, 60°, 75°, 90°, 105° and 12

Give me a wrong or muddled explanation of 4. Construct any acute angle using the tangent a

Set me five practice tasks on success: all ten circle parts correctly labelled and spacing

Give me a practice set on incentre construction using angle bisectors for SS1 Technical Dr

Set me five practice tasks on sheet sizes and line types, at the level expected in SS1 Dra

Set me five practice tasks on success: both projection symbols drawn to correct proportion

Give me a practice set on revision: timed construction drills, board-work clinic on weak c

Write a short SS1 Technical Drawing answer about 4. Compare the three methods for accuracy

Give me a wrong or muddled explanation of 4. Construct a diagonal scale and use it to read

Quiz me on 2. Distinguish between enlargement by ratio of sides and by ratio of areas, fro

You are my personal SS1 Technical Drawing tutor. Teach me 1. Enlarge a given plane figure

I am revising Enlargement and Reduction II for SS1 Technical Drawing. Test me on 2. Reduce

Give me a wrong or muddled explanation of 4. Identify the constructions used to transfer a

I am an SS1 student studying Tangents and Tangency II in Technical Drawing. Explain 2. Con

Act as my study partner. I will teach you 4. Relate loci to the motion produced by levers,

Set me five practice tasks on construction accuracy reported separately to parents, at the

Set me five practice tasks on success: ellipse constructed by all three methods, at the le