283 prompts matching "Success: all ten circle parts correctly labelled and spacings accurate to 0.5 mm"
Spot my mistake: Four line types used in orthographic drawing and the purpose of each
Show me a worked example on four line types used in orthographic drawing and the purpose o
Spot my mistake: Dimension a drawing using the aligned and the unidirectional system
Show me a worked example on dimension a drawing using the aligned and the unidirectional s
Teach me: Applying conventions for radii, diameters, holes, chamfers and repeated features
You are my personal SS2 Technical Drawing tutor. Teach me applying conventions for radii,
Real-life Nigeria: Drawing and fully dimension a bracket in third angle projection
Take drawing and fully dimension a bracket in third angle projection out of the textbook.
Teach me: Add a sectional view on a stated cutting plane, hatched at 45 degrees, and label it A-A
I am an SS2 student studying Orthographic Projection III in Technical Drawing. Explain add
Project task: Enclosing box on the board and removes material step by step so the class sees the isometric
Give me a practical task on enclosing box on the board and removes material step by step s
Real-life Nigeria: Drawing a first auxiliary elevation and a first auxiliary plan of a shaped block on one A3
Take drawing a first auxiliary elevation and a first auxiliary plan of a shaped block on o
Quiz: Drawing a second auxiliary elevation and a second auxiliary plan of a shaped block
Quiz me on drawing a second auxiliary elevation and a second auxiliary plan of a shaped bl
Spot my mistake: Drawing the auxiliary views of a full hexagonal prism and a square pyramid
Show me a worked example on drawing the auxiliary views of a full hexagonal prism and a sq
Quiz: Assessed AO1 and AO3
I am revising Auxiliary Views II for SS2 Technical Drawing. Test me on assessed AO1 and AO
Spot my mistake: Drawing the second auxiliary elevation of a shaped block and label both new ground lines
Show me a worked example on drawing the second auxiliary elevation of a shaped block and l
Project task: LINE, OFFSET, TRIM and ELLIPSE commands on the projector
Give me a practical task on LINE, OFFSET, TRIM and ELLIPSE commands on the projector from
Spot my mistake: Producing and plot an isometric drawing of a given block at 1:1 on A3
Show me a worked example on producing and plot an isometric drawing of a given block at 1:
Practice set: Why layers, rather than a single drawing layer, are used for outline and hidden detail
Set me five practice tasks on why layers, rather than a single drawing layer, are used for
Practice set: Rotating the UCS and setting up a viewport so the auxiliary direction becomes horizontal on
Give me a practice set on rotating the UCS and setting up a viewport so the auxiliary dire
Spot my mistake: Produce, dimension and plot an auxiliary elevation of a truncated solid on A3 at 1:1
Show me a worked example on produce, dimension and plot an auxiliary elevation of a trunca
Spot my mistake: Drawing the plan and elevation of five points at stated distances above the HP
Show me a worked example on drawing the plan and elevation of five points at stated distan
Practice set: What is meant by the first quadrant and why technical drawing works within it
Set me five practice tasks on what is meant by the first quadrant and why technical drawin
Practice set: Card triangle in the two-plane model and turns it until the class sees it edge-on
Give me a practice set on card triangle in the two-plane model and turns it until the clas
Teach me: By shape a trowel, plumb bob, spirit level, mason's square, float, bolster and jointer
I am an SS2 student studying Building Tools and Freehand Sketching in Technical Drawing. E