Technical Drawing

I am going to explain assessed AO3, and truncated solids in auxiliary projection are frequ

Set me a small project on autumn Term true-shape method and sets it beside the auxiliary m

Take drawing the auxiliary plan of a cylinder 50 mm diameter truncated at 40 degrees out o

Give me a practice set on compile a short class error list from marked work for SS2 Techni

Give me a wrong or muddled explanation of set up an AutoCAD drawing: units, limits from th

Give me a practical task on LINE, OFFSET, TRIM and ELLIPSE commands on the projector from

Show me how time the CAD version against the board version of the same block from Week 5 w

Set me five practice tasks on why layers, rather than a single drawing layer, are used for

Let me talk you through plotting the finished sheet to A3, save it as a PDF and file it in

Give me a practice set on rotating the UCS and setting up a viewport so the auxiliary dire

Set me a small project on drawing a truncated hexagonal prism, produce its auxiliary eleva

Take comparing the CAD auxiliary with their Week 8 board drawing out of the textbook. Desc

Set me five practice tasks on CAD against manual drawing for this task, at the level expec

Write a short SS2 Technical Drawing answer about the meaning of the horizontal plane, the

Set me a quick recall test on locate points at stated distances above the HP at SS2 level.

I am going to explain determine the horizontal trace and vertical trace of a line inclined

Give me a wrong or muddled explanation of assessed AO1 and AO2 from the Traces of Points a

Give me a practical task on plotting six points at given distances above the HP from Trace

Show me how are given a plan and elevation only and must state the position of each point

Give me a practice set on rod at an angle to both card planes and rotates it into a positi