296 prompts matching "And names each item in a full drawing set"
Let me explain: Reinforced concrete columns and beams
I have just studied reinforced concrete columns and beams in my SS3 Technical Drawing clas
Let me explain: Plumbing symbols and pipe runs
I have just studied plumbing symbols and pipe runs in my SS3 Technical Drawing class. Let
Practice set: Adding services to a given floor plan
Act as my SS3 Technical Drawing tutor. Give me five practice questions on adding services
Let me explain: Representing timber, insulation and hardcore
I have just studied representing timber, insulation and hardcore in my SS3 Technical Drawi
Let me explain: Reading weld size and length from a symbol
I have just studied reading weld size and length from a symbol in my SS3 Technical Drawing
Practice set: Annotating a joint with the correct weld symbol
Act as my SS3 Technical Drawing tutor. Give me five practice questions on annotating a joi
Let me explain: Clearance, interference and transition fits
I have just studied clearance, interference and transition fits in my SS3 Technical Drawin
Practice set: Computing limits from a stated fit
Act as my SS3 Technical Drawing tutor. Give me five practice questions on computing limits
Let me explain: Spring washers and tab washers
I have just studied spring washers and tab washers in my SS3 Technical Drawing class. Let
Let me explain: Removed and revolved sections
I have just studied removed and revolved sections in my SS3 Technical Drawing class. Let m
Practice set: Choosing the right section type for a given part
Act as my SS3 Technical Drawing tutor. Give me five practice questions on choosing the rig
Let me explain: Oblique circles and curves
I have just studied oblique circles and curves in my SS3 Technical Drawing class. Let me e
Let me explain: Setting up a two-point perspective
I have just studied setting up a two-point perspective in my SS3 Technical Drawing class.
Practice set: Finding the intersection of two given planes
Act as my SS3 Technical Drawing tutor. Give me five practice questions on finding the inte
Practice set: Developing a transition piece
Act as my SS3 Technical Drawing tutor. Give me five practice questions on developing a tra
Practice set: Locating the centre of gravity of a given lamina
Act as my SS3 Technical Drawing tutor. Give me five practice questions on locating the cen
Spot my mistake: Reading the representative fraction as the ratio of the drawing to the sheet rather than to the object
Act as my SS3 Technical Drawing tutor. Write a short answer on reading the representative
Spot my mistake: Treating a chord and a diameter as interchangeable when finding the centre of an arc
Act as my SS3 Technical Drawing tutor. Write a short answer on treating a chord and a diam
Spot my mistake: Drawing a tangent that meets the radius at the point of contact at any convenient angle
Act as my SS3 Technical Drawing tutor. Write a short answer on drawing a tangent that meet
Spot my mistake: Treating an isometric drawing as a perspective view with lines converging on a vanishing point
Act as my SS3 Technical Drawing tutor. Write a short answer on treating an isometric drawi