205 prompts matching "CAD against manual drawing for this task"
Practice set: Cavalier and cabinet oblique of the same block so students can see the halved receding depth.
Give me a practice set on cavalier and cabinet oblique of the same block so students can s
Practice set: Portfolio and board accuracy recorded separately
Set me five practice tasks on portfolio and board accuracy recorded separately, at the lev
Spot my mistake: Producing a sheet using at least five instruments correctly
Show me a worked example on producing a sheet using at least five instruments correctly wi
Let me explain: 3. Describe the purpose of lettering
I am going to explain 3. Describe the purpose of lettering to you, as an SS1 Technical Dra
Spot my mistake: Producing vertical and inclined lettering to consistent height
Show me a worked example on producing vertical and inclined lettering to consistent height
Spot my mistake: 4. Apply studio rules consistently and maintain instruments in working order
Show me a worked example on 4. Apply studio rules consistently and maintain instruments in
Spot my mistake: Practise healthy habits
Show me a worked example on practise healthy habits with an error somewhere in it. Do not
WAEC prep: Producing a hazard-and-control chart
Act as my WAEC Technical Drawing examiner. I am in SS1. Set me an exam-standard question o
Spot my mistake: 4. Divide a straight line into any number of equal segments and into a given ratio
Write a short SS1 Technical Drawing answer about 4. Divide a straight line into any number
Spot my mistake: And produce all six line types at correct weight
Show me a worked example on and produce all six line types at correct weight with an error
WAEC prep: Success: division into seven parts accurate to within 0.5 mm across the whole line
Act as my WAEC Technical Drawing examiner. I am in SS1. Set me an exam-standard question o
Let me explain: 3. Construct the special angles 30°, 45°, 60°, 75°, 90°, 105° and 120° using compasses only
I am going to explain 3. Construct the special angles 30°, 45°, 60°, 75°, 90°, 105° and 12
Spot my mistake: Success: every constructed angle within ±1° when checked with a protractor
Show me a worked example on success: every constructed angle within ±1° when checked with
Spot my mistake: Given two sides and the included angle
Show me a worked example on given two sides and the included angle with an error somewhere
WAEC prep: The classification of triangles by side and by angle
Act as my WAEC Technical Drawing examiner. I am in SS1. Set me an exam-standard question o
Spot my mistake: Success: all three constructions within 0.5 mm and ±1° of the specified data
Show me a worked example on success: all three constructions within 0.5 mm and ±1° of the
Spot my mistake: 2. Draw a circle and label its parts correctly
Write a short SS1 Technical Drawing answer about 2. Draw a circle and label its parts corr
WAEC prep: Constructing eccentric and concentric circles to specification
Act as my WAEC Technical Drawing examiner. I am in SS1. Set me an exam-standard question o
Let me explain: 1. Inscribe a circle in a given triangle
I am going to explain 1. Inscribe a circle in a given triangle to you, as an SS1 Technical
WAEC prep: Success: all three circles tangent or passing through the correct points within 0.5 mm
Act as my WAEC Technical Drawing examiner. I am in SS1. Set me an exam-standard question o