228 prompts matching "Let me explain: Drawing an isometric circle by the four-centre method"
WAEC prep: Producing a hazard-and-control chart
Act as my WAEC Technical Drawing examiner. I am in SS1. Set me an exam-standard question o
Real-life Nigeria: Each line type against the standard line chart. Students produce a reference sheet showing all
Show me how each line type against the standard line chart. Students produce a reference s
Spot my mistake: And produce all six line types at correct weight
Show me a worked example on and produce all six line types at correct weight with an error
Spot my mistake: Success: every constructed angle within ±1° when checked with a protractor
Show me a worked example on success: every constructed angle within ±1° when checked with
Spot my mistake: Given two sides and the included angle
Show me a worked example on given two sides and the included angle with an error somewhere
Quiz: 4. Construct a triangle equal in area to a given quadrilateral and locate the centroid
I am revising Angles and Triangles II for SS1 Technical Drawing. Test me on 4. Construct a
Spot my mistake: Success: all three constructions within 0.5 mm and ±1° of the specified data
Show me a worked example on success: all three constructions within 0.5 mm and ±1° of the
Practice set: Incentre construction using angle bisectors
Give me a practice set on incentre construction using angle bisectors for SS1 Technical Dr
Quiz: 4. Construct any quadrilateral when four sides and one diagonal are known
I am revising Quadrilaterals for SS1 Technical Drawing. Test me on 4. Construct any quadri
Project task: Completing a properties table for the six quadrilaterals
Give me a practical task on completing a properties table for the six quadrilaterals from
Spot my mistake: Constructing special quadrilaterals and one from four sides and a diagonal
Show me a worked example on constructing special quadrilaterals and one from four sides an
WAEC prep: Success: constructed quadrilateral closes with an error of less than 0.5 mm
Act as my WAEC Technical Drawing examiner. I am in SS1. Set me an exam-standard question o
Real-life Nigeria: Standard line-type and abbreviation tables. Students produce a reference sheet showing sheet
Show me how standard line-type and abbreviation tables. Students produce a reference sheet
Practice set: Revision: timed construction drills, board-work clinic on weak constructions
Give me a practice set on revision: timed construction drills, board-work clinic on weak c
Spot my mistake: 4. Calculate the interior and exterior angles of any regular polygon
Show me a worked example on 4. Calculate the interior and exterior angles of any regular p
Quiz: 2. Reduce a given plane figure based on a ratio of areas
I am revising Enlargement and Reduction II for SS1 Technical Drawing. Test me on 2. Reduce
Real-life Nigeria: Enlarge an irregular pentagon in the ratio of areas 3:2
Show me how enlarge an irregular pentagon in the ratio of areas 3:2 works in real life in
Teach me: 1. Outline the principles of determining figures of equal area
I am an SS1 student studying Equal Areas of Similar Figures I in Technical Drawing. Explai
WAEC prep: Success: all six diagram pairs correctly judged with a valid geometric reason for each
Act as my WAEC Technical Drawing examiner. I am in SS1. Set me an exam-standard question o
Spot my mistake: Success: calculated areas of original and converted figures agree within 2%
Show me a worked example on success: calculated areas of original and converted figures ag