272 prompts matching "Quiz: 4. Construct any quadrilateral when four sides and one diagonal are known"
Let me explain: Pad and raft foundations
I have just studied pad and raft foundations in my SS3 Technical Drawing class. Let me exp
Let me explain: Suspended timber floors and their members
I have just studied suspended timber floors and their members in my SS3 Technical Drawing
Teach me: Tread, riser, going and pitch
You are my personal SS3 Technical Drawing tutor. Teach me tread, riser, going and pitch, u
Let me explain: The strings, newel and balustrade
I have just studied the strings, newel and balustrade in my SS3 Technical Drawing class. L
Teach me: Load bearing and non-load bearing walls
You are my personal SS3 Technical Drawing tutor. Teach me load bearing and non-load bearin
Let me explain: Reinforced concrete columns and beams
I have just studied reinforced concrete columns and beams in my SS3 Technical Drawing clas
Practice set: Drawing a detail at a wall and beam junction
Act as my SS3 Technical Drawing tutor. Give me five practice questions on drawing a detail
Let me explain: Plumbing symbols and pipe runs
I have just studied plumbing symbols and pipe runs in my SS3 Technical Drawing class. Let
Let me explain: Representing timber, insulation and hardcore
I have just studied representing timber, insulation and hardcore in my SS3 Technical Drawi
Let me explain: Reading weld size and length from a symbol
I have just studied reading weld size and length from a symbol in my SS3 Technical Drawing
Teach me: What a tolerance is and why it is specified
You are my personal SS3 Technical Drawing tutor. Teach me what a tolerance is and why it i
Let me explain: Clearance, interference and transition fits
I have just studied clearance, interference and transition fits in my SS3 Technical Drawin
Let me explain: Bolts, studs and set screws
I have just studied bolts, studs and set screws in my SS3 Technical Drawing class. Let me
Let me explain: Spring washers and tab washers
I have just studied spring washers and tab washers in my SS3 Technical Drawing class. Let
Teach me: The offset section and its stepped cutting plane
You are my personal SS3 Technical Drawing tutor. Teach me the offset section and its stepp
Let me explain: Removed and revolved sections
I have just studied removed and revolved sections in my SS3 Technical Drawing class. Let m
Let me explain: Drawing an isometric circle by the four-centre method
I have just studied drawing an isometric circle by the four-centre method in my SS3 Technical Drawing class. Let me explain it back to you in my own words, then tell me plainly what I got wrong or left out. Ask me one follow-up question afterwards to test whether I really understood it.
launch and paste in:
Teach me: Cavalier and cabinet oblique
You are my personal SS3 Technical Drawing tutor. Teach me cavalier and cabinet oblique, us
Let me explain: Oblique circles and curves
I have just studied oblique circles and curves in my SS3 Technical Drawing class. Let me e
Teach me: The horizon line, vanishing point and station point
You are my personal SS3 Technical Drawing tutor. Teach me the horizon line, vanishing poin