Technical Drawing

Show me a worked example on what happens to the output at a dead-centre position with an e

You are my personal SS2 Technical Drawing tutor. Teach me what is meant by the true shape

I am an SS2 student studying True Shapes I in Technical Drawing. Explain assessed AO3, and

Give me a practice set on modelling-clay cone at four angles in front of the class for SS2

Be my SS2 Technical Drawing teacher for this one point: the true shape obtained with the s

Give me a practice set on one truncated hexagonal prism on the board for SS2 Technical Dra

Act as my study partner. I will teach you develop the surface of a truncated hexagonal pri

You are my personal SS2 Technical Drawing tutor. Teach me the finished models for accuracy

Give me a practical task on set out the development of their Week 6 truncated cone on card

Show me how display the finished models beside the drawings works in real life in Nigeria.

Set me five practice tasks on your model against the drawing, at the level expected in SS2

Write a short SS2 Technical Drawing answer about determine the curve of intersection of tw

I am going to explain assessed AO3, and intersecting cylinders appear in WAEC and NECO Pap

Give me a practice set on paper tube into a slot cut in a larger tube to show the saddle c

Set me a small project on drawing two cylinders of 50 mm and 30 mm diameter meeting at 90

Take develop the branch cylinder, cut the pattern in card out of the textbook. Describe a

Set me five practice tasks on why the curve becomes two straight lines when the two cylind

Give me a wrong or muddled explanation of determine the lines of intersection of two regul

Be my SS2 Technical Drawing teacher for this one point: determine the lines of intersectio

Give me a practical task on determine the intersection of a 30 mm square prism entering a