228 prompts matching "Quiz: The position of the plan and end views"
Real-life Nigeria: Dimensioning rules with examples of correct
Take dimensioning rules with examples of correct out of the textbook. Describe a real Nige
Practice set: Dimension circles, arcs, chamfers and vertical, horizontal and angular shapes correctly
Set me five practice tasks on dimension circles, arcs, chamfers and vertical, horizontal a
Project task: Building a composite object in isometric from three orthographic views
Give me a practical task on building a composite object in isometric from three orthograph
Practice set: Producing a composite isometric drawing from orthographic views
Set me five practice tasks on producing a composite isometric drawing from orthographic vi
Teach me: 2. Use a graphics package for lettering and for drawing lines and angles
You are my personal SS1 Technical Drawing tutor. Teach me 2. Use a graphics package for le
Spot my mistake: Full-year synoptic review
Write a short SS1 Technical Drawing answer about full-year synoptic review that contains t
Practice set: And names each item in a full drawing set
Give me a practice set on and names each item in a full drawing set for SS1 Technical Draw
WAEC prep: Success: sheet completed with correct pencil grade for outline, construction and dimension lines
Act as my WAEC Technical Drawing examiner. I am in SS1. Set me an exam-standard question o
WAEC prep: Producing a hazard-and-control chart
Act as my WAEC Technical Drawing examiner. I am in SS1. Set me an exam-standard question o
WAEC prep: Success: division into seven parts accurate to within 0.5 mm across the whole line
Act as my WAEC Technical Drawing examiner. I am in SS1. Set me an exam-standard question o
Practice set: Constructing the special angles without a protractor
Set me five practice tasks on constructing the special angles without a protractor, at the
Spot my mistake: 2. Draw a circle and label its parts correctly
Write a short SS1 Technical Drawing answer about 2. Draw a circle and label its parts corr
Teach me: 3. Distinguish eccentric from concentric circles and illustrate each
I am an SS1 student studying Circles and Triangles I in Technical Drawing. Explain 3. Dist
WAEC prep: Constructing eccentric and concentric circles to specification
Act as my WAEC Technical Drawing examiner. I am in SS1. Set me an exam-standard question o
Practice set: Success: all ten circle parts correctly labelled and spacings accurate to 0.5 mm
Set me five practice tasks on success: all ten circle parts correctly labelled and spacing
Teach me: 3. Describe an escribed circle and construct one to a given triangle
Be my SS1 Technical Drawing teacher for this one point: 3. Describe an escribed circle and
WAEC prep: Success: all three circles tangent or passing through the correct points within 0.5 mm
Act as my WAEC Technical Drawing examiner. I am in SS1. Set me an exam-standard question o
Project task: Completing a properties table for the six quadrilaterals
Give me a practical task on completing a properties table for the six quadrilaterals from
Practice set: Sheet sizes and line types
Set me five practice tasks on sheet sizes and line types, at the level expected in SS1 Dra
WAEC prep: Five standard abbreviations with meanings
Act as my WAEC Technical Drawing examiner. I am in SS1. Set me an exam-standard question o