296 prompts matching "Time the CAD version against the board version of the same block from Week 5"
Teach me: The hatching conventions for common building materials
You are my personal SS3 Technical Drawing tutor. Teach me the hatching conventions for com
Spot my mistake: A section hatched with the wrong material convention
Act as my SS3 Technical Drawing tutor. Write a short answer on a section hatched with the
Practice set: Annotating a joint with the correct weld symbol
Act as my SS3 Technical Drawing tutor. Give me five practice questions on annotating a joi
Teach me: The full section and when it is used
You are my personal SS3 Technical Drawing tutor. Teach me the full section and when it is
Let me explain: The part or local section
I have just studied the part or local section in my SS3 Technical Drawing class. Let me ex
Practice set: Choosing the right section type for a given part
Act as my SS3 Technical Drawing tutor. Give me five practice questions on choosing the rig
Let me explain: Drawing an isometric circle by the four-centre method
I have just studied drawing an isometric circle by the four-centre method in my SS3 Technical Drawing class. Let me explain it back to you in my own words, then tell me plainly what I got wrong or left out. Ask me one follow-up question afterwards to test whether I really understood it.
launch and paste in:
Teach me: The horizon line, vanishing point and station point
You are my personal SS3 Technical Drawing tutor. Teach me the horizon line, vanishing poin
Teach me: How the object sits relative to the planes in first angle
You are my personal SS3 Technical Drawing tutor. Teach me how the object sits relative to
Teach me: How the planes lie between viewer and object in third angle
You are my personal SS3 Technical Drawing tutor. Teach me how the planes lie between viewe
Spot my mistake: Treating an ellipse as a shape struck from four centres rather than plotted as a locus
Act as my SS3 Technical Drawing tutor. Write a short answer on treating an ellipse as a sh
Spot my mistake: Placing the plan above the front view in first angle projection
Act as my SS3 Technical Drawing tutor. Write a short answer on placing the plan above the
Spot my mistake: Projecting an auxiliary view at right angles to the frontal plane rather than to the inclined face
Act as my SS3 Technical Drawing tutor. Write a short answer on projecting an auxiliary vie
Spot my mistake: Hatching the whole sectional view rather than only what the cutting plane passes through
Act as my SS3 Technical Drawing tutor. Write a short answer on hatching the whole sectiona
Spot my mistake: Assuming every floor in a building is a solid floor cast on the ground
Act as my SS3 Technical Drawing tutor. Write a short answer on assuming every floor in a b
Spot my mistake: Reading a floor plan as a view from above rather than as a horizontal section through the building
Act as my SS3 Technical Drawing tutor. Write a short answer on reading a floor plan as a v
Spot my mistake: Assuming a raft foundation is chosen where the ground is strongest
Act as my SS3 Technical Drawing tutor. Write a short answer on assuming a raft foundation
Spot my mistake: Reading a weld symbol below the reference line as though it sat above it
Act as my SS3 Technical Drawing tutor. Write a short answer on reading a weld symbol below
Spot my mistake: Assuming a line inclined in both views can have its true length measured in either
Act as my SS3 Technical Drawing tutor. Write a short answer on assuming a line inclined in
Spot my mistake: Measuring the angle between two planes in a view where neither appears as an edge
Act as my SS3 Technical Drawing tutor. Write a short answer on measuring the angle between