Technical Drawing

Set me five practice tasks on success: both folded models close with a gap of less than 2

Set me a quick recall test on 2. Place dimensions on circles, arcs and chamfers at SS1 lev

Set me five practice tasks on dimension circles, arcs, chamfers and vertical, horizontal a

Give me a practice set on four-centre ellipse inside an isometric rhombus. Students constr

Set me five practice tasks on constructing isometric squares, rectangles, arcs and circles

Set me five practice tasks on producing a composite isometric drawing from orthographic vi

Set me five practice tasks on constructing the special angles without a protractor, at the

Set me five practice tasks on success: all ten circle parts correctly labelled and spacing

Show me a worked example on calculating the linear ratio from a given area ratio with an e

Act as my study partner. I will teach you 3. Develop the pattern for a transition piece be

Set me five practice tasks on first- and third-angle projection compared, at the level exp

Show me a worked example on producing three correct views of a given solid with an error s

Show me a worked example on success: both drawings fully dimensioned with an error somewhe

Act as my study partner. I will teach you 3. Differentiate between isometric and non-isome

Show me a worked example on success: four-centre ellipses drawn correctly in all three pla

Set me five practice tasks on portfolio and board accuracy recorded separately, at the lev

Show me a worked example on producing vertical and inclined lettering to consistent height

Show me a worked example on 4. Apply studio rules consistently and maintain instruments in

Show me a worked example on and produce all six line types at correct weight with an error

Show me a worked example on constructing an inscribed, a circumscribed and an escribed cir