228 prompts matching "Swap sheets and mark each other's work against a three-point checklist"
WAEC prep: Success: constructed quadrilateral closes with an error of less than 0.5 mm
Act as my WAEC Technical Drawing examiner. I am in SS1. Set me an exam-standard question o
Practice set: Accuracy of construction assessed separately from knowledge
Set me five practice tasks on accuracy of construction assessed separately from knowledge,
Quiz: 2. Construct a regular polygon using the circle (circumscribing) method
I am revising Polygons II for SS1 Technical Drawing. Test me on 2. Construct a regular pol
WAEC prep: Success: sides of the heptagon equal within 0.5 mm by at least two of the three methods
Act as my WAEC Technical Drawing examiner. I am in SS1. Set me an exam-standard question o
Practice set: Success: five dimensions set off from the diagonal scale correct within 0.5 mm
Set me five practice tasks on success: five dimensions set off from the diagonal scale cor
WAEC prep: Success: all five scale-factor calculations correct to two decimal places
Act as my WAEC Technical Drawing examiner. I am in SS1. Set me an exam-standard question o
Quiz: 2. Reduce a given plane figure based on a ratio of areas
I am revising Enlargement and Reduction II for SS1 Technical Drawing. Test me on 2. Reduce
Quiz: 3. Construct an arc tangent to a straight line
I am revising Tangents and Tangency I for SS1 Technical Drawing. Test me on 3. Construct a
WAEC prep: Success: crank locus plotted at twelve positions forming a smooth closed curve
Act as my WAEC Technical Drawing examiner. I am in SS1. Set me an exam-standard question o
Practice set: Construction accuracy reported separately to parents
Set me five practice tasks on construction accuracy reported separately to parents, at the
Practice set: Success: ellipse constructed by all three methods
Set me five practice tasks on success: ellipse constructed by all three methods, at the le
Practice set: Success: both folded models close with a gap of less than 2 mm
Set me five practice tasks on success: both folded models close with a gap of less than 2
WAEC prep: Success: truncated cylinder model assembled
Act as my WAEC Technical Drawing examiner. I am in SS1. Set me an exam-standard question o
WAEC prep: Success: all three views correctly aligned by projection
Act as my WAEC Technical Drawing examiner. I am in SS1. Set me an exam-standard question o
WAEC prep: Success: all three solids drawn with axes at 30° ±1°
Act as my WAEC Technical Drawing examiner. I am in SS1. Set me an exam-standard question o
Quiz: 2. Construct isometric circles as four-centre ellipses in all three isometric planes
I am revising Isometric Drawing II for SS1 Technical Drawing. Test me on 2. Construct isom
Quiz: 2. Demonstrate the use of shading to enhance an isometric drawing
Set me a quick recall test on 2. Demonstrate the use of shading to enhance an isometric dr
Practice set: Producing a composite isometric drawing from orthographic views
Set me five practice tasks on producing a composite isometric drawing from orthographic vi
Practice set: Success: cabinet oblique drawn with receding dimensions correctly halved
Set me five practice tasks on success: cabinet oblique drawn with receding dimensions corr
WAEC prep: Promotion decision informed by objective-level analysis
Act as my WAEC Technical Drawing examiner. I am in SS1. Set me an exam-standard question o