227 prompts matching "Applying tangency to a spanner or anchor outline"
Spot my mistake: 4. Use drawing materials and instruments correctly to produce simple drawings of objects
Write a short SS1 Technical Drawing answer about 4. Use drawing materials and instruments
WAEC prep: Success: sheet completed with correct pencil grade for outline, construction and dimension lines
Act as my WAEC Technical Drawing examiner. I am in SS1. Set me an exam-standard question o
Quiz: 2. Prepare a title block and border to standard proportions on a drawing sheet
Set me a quick recall test on 2. Prepare a title block and border to standard proportions
Practice set: Preparing a title block to given proportions
Set me five practice tasks on preparing a title block to given proportions, at the level e
Practice set: Constructing the special angles without a protractor
Set me five practice tasks on constructing the special angles without a protractor, at the
Spot my mistake: Success: every constructed angle within ±1° when checked with a protractor
Show me a worked example on success: every constructed angle within ±1° when checked with
Practice set: Success: all ten circle parts correctly labelled and spacings accurate to 0.5 mm
Set me five practice tasks on success: all ten circle parts correctly labelled and spacing
Quiz: 4. Explain the geometric basis of each construction using bisectors
Quiz me on 4. Explain the geometric basis of each construction using bisectors, from the S
Practice set: Incentre construction using angle bisectors
Give me a practice set on incentre construction using angle bisectors for SS1 Technical Dr
Practice set: Success: both projection symbols drawn to correct proportion and correctly identified
Set me five practice tasks on success: both projection symbols drawn to correct proportion
Spot my mistake: 4. Determine the linear ratio corresponding to a given ratio of areas
Show me a worked example on 4. Determine the linear ratio corresponding to a given ratio o
WAEC prep: Success: all five scale-factor calculations correct to two decimal places
Act as my WAEC Technical Drawing examiner. I am in SS1. Set me an exam-standard question o
Real-life Nigeria: Work through the three arc-tangency cases from given data
Take work through the three arc-tangency cases from given data out of the textbook. Descri
Spot my mistake: Constructing arcs internally touching, externally enclosing and mixed for two circles
Show me a worked example on constructing arcs internally touching, externally enclosing an
Practice set: Construction accuracy reported separately to parents
Set me five practice tasks on construction accuracy reported separately to parents, at the
Teach me: 1. Identify the types of pictorial drawing: isometric, oblique and perspective
Be my SS1 Technical Drawing teacher for this one point: 1. Identify the types of pictorial
Quiz: 2. Define isometric drawing and the isometric axes at 30° to the horizontal
Quiz me on 2. Define isometric drawing and the isometric axes at 30° to the horizontal, fr
Teach me: 1. Describe the concept of perspective in pictorial drawing and its effect on the shapes created
I am an SS1 student studying Isometric Drawing III in Technical Drawing. Explain 1. Descri
Spot my mistake: 1. Explain what CAD is and compare CAD with manual drawing for accuracy, revision and storage
Show me a worked example on 1. Explain what CAD is and compare CAD with manual drawing for
Quiz: 3. Use a graphics package to produce plane and pictorial figures
I am revising Introduction to Computer Graphics and Cad for SS1 Technical Drawing. Test me