Technical Drawing

Be my SS2 Technical Drawing teacher for this one point: drawing the tangent and normal at

You are my personal SS2 Technical Drawing tutor. Teach me constructing an epicycloid and a

Give me a practice set on out the standard layout on the board, moving the station point t

Take constructing an involute of a circle and a cycloid on one A3 sheet out of the textboo

I am going to explain rendering the finished view with tone and texture to distinguish two

I am going to explain sketching freehand front, top and side views of two of the same tool

Quiz me on constructing the involute of a circle of 40 mm diameter for one complete revolu

Write a short SS2 Technical Drawing answer about set out two vanishing points on the horiz

Set me a quick recall test on drawing a circle in perspective by enclosing it in a square

Show me a worked example on in two sentences why a parabolic dish concentrates a signal at

Set me a quick recall test on constructing a parabola by the focus and directrix method fo

Give me a wrong or muddled explanation of constructing a hyperbola from given foci and a c

Act as my study partner. I will teach you constructing the involute of a square and of a r

Show me a worked example on constructing a cycloid generated by a 40 mm diameter circle ro

Quiz me on drawing a slider-crank mechanism and plot the locus of the mid-point of the con

You are my personal SS2 Technical Drawing tutor. Teach me and locate the ground line, hori

Take visual ray method, drawing rays from the station point through each plan corner to th

Set me five practice tasks on why the height of a point is transferred unchanged into an a

Show me a worked example on constructing orthographic views of a truncated solid in AutoCA

I am an SS2 student studying Traces of Points and Lines in Technical Drawing. Explain proj