Technical Drawing

I am going to explain 3. Construct the special angles 30°, 45°, 60°, 75°, 90°, 105° and 12

Let me talk you through 3. Produce the front elevation, end elevation and plan of a given

Let me talk you through 3. State the advantages of CADD over manual drawing from the Drawi

Let me talk you through 1. State the purpose of drawing standards from the Drawing Standar

Act as my study partner. I will teach you 4. Relate loci to the motion produced by levers,

Act as my study partner. I will teach you 4. Construct an oblique drawing using the centre

I am going to explain 3. Describe the purpose of lettering to you, as an SS1 Technical Dra

Quiz me on 4. Explain the geometric basis of each construction using bisectors, from the S

I am going to explain consolidation of drawing practice, line work to you, as an SS1 Techn

Let me talk you through 3. Construct a regular polygon using the diagonal method from the

I am going to explain 3. Construct a plain scale to a given representative fraction to you

Let me talk you through 3. Apply the radial (ray) method of enlargement from a chosen pole

I am going to explain 3. Explain why triangles on the same base and between the same paral

Let me talk you through 4. Construct common tangents to two equal and to two unequal circl

Let me talk you through 2. Construct an ellipse by the four-centre, concentric-circles and

I am going to explain 3. Determine true lengths of the edges of full and truncated solids

I am an SS1 student studying Isometric Drawing III in Technical Drawing. Explain 1. Descri

I am going to explain 3. Use construction layers to build up complex isometric shapes to y

Act as my study partner. I will teach you 4. Convert a given irregular polygon into a tria

Be my SS1 Technical Drawing teacher for this one point: 1. Identify the types of pictorial