Technical Drawing

Give me a wrong or muddled explanation of drawing a four-bar linkage to given link lengths

Give me a practice set on cutting paper cylinder to show that the seam edge of the develop

Give me a practice set on out the standard layout on the board, moving the station point t

Show me how drawing three first angle views of a shaped block from a given pictorial view

Set me five practice tasks on fully dimension a given third angle drawing, using at least

Show me how converting a given first angle drawing into an isometric view works in real li

Quiz me on straight-flight, quarter-turn, half-turn or dog-leg, and geometrical or spiral

Show me a worked example on what happens to the output at a dead-centre position with an e

Show me a worked example on labelling five terms on a given perspective layout with an err

Give me a practical task on card box round a small block to show the three planes opening

Set me five practice tasks on convert given orthographic views into an isometric view draw

Set me a quick recall test on set out a segmental arch geometrically and mark voussoir joi

I am going to explain constructing a parabola inside a given rectangle 100 mm by 60 mm by

Write a short SS2 Technical Drawing answer about constructing an isometric view from given

Show me how are given a plan and elevation only and must state the position of each point

Give me a practical task on roll a tin lid along a straight edge and plot from Loci and Sp

Set me five practice tasks on sketching the locus of a point on the rim of a wheel rolling

Give me a wrong or muddled explanation of constructing a hyperbola from given foci and a c

Give me a practice set on paper tube into a slot cut in a larger tube to show the saddle c

Set me five practice tasks on why the curve becomes two straight lines when the two cylind