Technical Drawing

Set me five practice tasks on fully dimension a given third angle drawing, using at least

Act as my WAEC Technical Drawing examiner. I am in SS2. Set me an exam-standard question o

Give me a practical task on LINE, OFFSET, TRIM and ELLIPSE commands on the projector from

Give me a practice set on point equidistant from two fixed points for SS2 Technical Drawin

Set me five practice tasks on sketching the locus of a point on the rim of a wheel rolling

Give me a practice set on listing five machines seen locally that use linkages for SS2 Tec

Set me five practice tasks on calculating the stroke of a slider-crank whose crank radius

Set me five practice tasks on the four conic sections and the cutting plane that produces

Set me five practice tasks on labelling the cutting plane, viewing arrows, at the level ex

Give me a practical task on set out the development of their Week 6 truncated cone on card

Set me five practice tasks on your model against the drawing, at the level expected in SS2

Set me five practice tasks on why the curve becomes two straight lines when the two cylind

Set me five practice tasks on the completed card assembly, at the level expected in SS2 In

Set me a small project on up a poorly dimensioned drawing on the board, the kind I could f

Set me five practice tasks on why the height of a point is transferred unchanged into an a

Set me five practice tasks on the sequence of steps needed to obtain a second auxiliary vi

Give me a practice set on compile a short class error list from marked work for SS2 Techni

Set me five practice tasks on why layers, rather than a single drawing layer, are used for

Give me a practice set on two planes from two sheets of card at right angles for SS2 Techn

Set me five practice tasks on what is meant by the first quadrant and why technical drawin