Technical Drawing

Quiz me on drawing a slider-crank mechanism and plot the locus of the mid-point of the con

Show me a worked example on why the cut face appears as a straight line in one view and an

Quiz me on develop the surfaces of the intersecting prisms and pyramids, showing the openi

Give me a practice set on vertical edges of both prisms and shows how each edge of the bra

Give me a practice set on out the standard layout on the board, moving the station point t

I am going to explain rendering the finished view with tone and texture to distinguish two

Set me five practice tasks on what is meant by the first quadrant and why technical drawin

Act as my WAEC Technical Drawing examiner. I am in SS2. Set me an exam-standard question o

Take constructing an involute of a circle and a cycloid on one A3 sheet out of the textboo

Show me a worked example on here the locus plot supplies the evidence with an error somewh

Show me a worked example on what happens to the output at a dead-centre position with an e

Take drawing a first auxiliary elevation and a first auxiliary plan of a shaped block on o

Write a short SS2 Technical Drawing answer about clockwise and anticlockwise motion and ro

Set me a quick recall test on sketching freehand the mechanism of a pair of scissors at SS

Set me five practice tasks on four components of a link mechanism, at the level expected i

You are my personal SS2 Technical Drawing tutor. Teach me what is meant by the true shape

Write a short SS2 Technical Drawing answer about the conic section produced by each of fou

Give me a practice set on one truncated hexagonal prism on the board for SS2 Technical Dra

Take swap sheets and mark each other's work against a three-point checklist out of the tex

Show me a worked example on cut, fold and assemble the developments in cardboard with an e