296 prompts matching "Why the cut face appears as a straight line in one view and an ellipse in anothe"
Spot my mistake: Showing the steps of an offset cutting plane as lines in the sectional view
Act as my SS3 Technical Drawing tutor. Write a short answer on showing the steps of an off
Teach me: Why a line appears shorter than its true length
You are my personal SS3 Technical Drawing tutor. Teach me why a line appears shorter than
Spot my mistake: Projecting an auxiliary view at right angles to the frontal plane rather than to the inclined face
Act as my SS3 Technical Drawing tutor. Write a short answer on projecting an auxiliary vie
Spot my mistake: Assuming the longer of the two given views of a line shows its true length
Act as my SS3 Technical Drawing tutor. Write a short answer on assuming the longer of the
Spot my mistake: Hatching the whole sectional view rather than only what the cutting plane passes through
Act as my SS3 Technical Drawing tutor. Write a short answer on hatching the whole sectiona
Spot my mistake: Developing the curved surface of a cone as a rectangle of the same height
Act as my SS3 Technical Drawing tutor. Write a short answer on developing the curved surfa
Spot my mistake: Reading the line joining two electrical symbols on a plan as the actual route of the cable
Act as my SS3 Technical Drawing tutor. Write a short answer on reading the line joining tw
Spot my mistake: Reading a weld symbol below the reference line as though it sat above it
Act as my SS3 Technical Drawing tutor. Write a short answer on reading a weld symbol below
Spot my mistake: Assuming the horizon line sits at the top of the sheet whatever the viewpoint
Act as my SS3 Technical Drawing tutor. Write a short answer on assuming the horizon line s
Spot my mistake: Assuming a line inclined in both views can have its true length measured in either
Act as my SS3 Technical Drawing tutor. Write a short answer on assuming a line inclined in
Spot my mistake: Measuring the angle between two planes in a view where neither appears as an edge
Act as my SS3 Technical Drawing tutor. Write a short answer on measuring the angle between
Spot my mistake: Assuming the centre of gravity of a lamina must lie within its outline
Act as my SS3 Technical Drawing tutor. Write a short answer on assuming the centre of grav
Teach me: Dividing a straight line into equal parts by construction
You are my personal SS3 Technical Drawing tutor. Teach me dividing a straight line into eq
Quiz: The true length of a line by rotation
Act as my SS3 Technical Drawing tutor and quiz me on the true length of a line by rotation
Let me explain: The angle of inclination of a line to a plane
I have just studied the angle of inclination of a line to a plane in my SS3 Technical Draw
Quiz: The cutting plane and its indication
Act as my SS3 Technical Drawing tutor and quiz me on the cutting plane and its indication.
Quiz: Developing the surface of a prism
Act as my SS3 Technical Drawing tutor and quiz me on developing the surface of a prism. As
Let me explain: Developing the surface of a cylinder
I have just studied developing the surface of a cylinder in my SS3 Technical Drawing class
Teach me: Why a fastener needs locking
You are my personal SS3 Technical Drawing tutor. Teach me why a fastener needs locking, us
WAEC prep: Non-isometric lines and how they are plotted
Act as a WAEC/NECO Technical Drawing examiner. I am in SS 3. Set me five exam-style questi